OPA341, 2341

2

SBOS202A

PACKAGE

SPECIFIED

DRAWING

PACKAGE

TEMPERATURE

PACKAGE

ORDERING

TRANSPORT

PRODUCT

PACKAGE

NUMBER

DESIGNATOR

RANGE

MARKING

MEDIA

OPA341NA

SOT23-6

332

—–55

°C to +125°C

B41

OPA341NA/250

Tape and Reel

""

"

—

""

OPA341NA/3K

Tape and Reel

OPA341UA

SO-8

182

—–55

°C to +125°C

OPA341UA

OPA341UA

Rails

""

"

—

""

OPA341UA/2K5

Tape and Reel

OPA2341DGSA

MSOP-10

4073272

DGS

–55

°C to +125°C

C41

OPA2341DGSA/250

Tape and Reel

""

"

"

"

"

OPA2341DGSA/2K5

Tape and Reel

NOTE: (1) Models with a slash (/) are available only in Tape and Reel in the quantities indicated (e.g., /3K indicates 3000 devices per reel). Ordering 3000 pieces

of “OPA341NA/3K” will get a single 3000-piece Tape and Reel..

Supply Voltage, V+ to V– ................................................................... 6.0V

Operating Temperature .................................................. –55

°C to +150°C

Storage Temperature ..................................................... –65

°C to +150°C

Junction Temperature ...................................................................... 150

°C

Lead Temperature (soldering, 10s) ................................................. 300

°C

ELECTROSTATIC

DISCHARGE SENSITIVITY

This integrated circuit can be damaged by ESD. Texas Instru-

ments recommends that all integrated circuits be handled with

appropriate precautions. Failure to observe proper handling

and installation procedures can cause damage.

ESD damage can range from subtle performance degradation

to complete device failure. Precision integrated circuits may

be more susceptible to damage because very small parametric

changes could cause the device not to meet its published

specifications.

PACKAGE/ORDERING INFORMATION

NOTES: (1) Stresses above these ratings may cause permanent damage.

Exposure to absolute maximum conditions for extended periods may de-

grade device reliability. (2) Input terminals are diode-clamped to the power

supply rails. Input signals that can swing more than 0.5V beyond the supply

rails should be current-limited to 10mA or less. (3) Short-circuit to ground,

one amplifier per package.