Electronic Components Datasheet Search |
|
AXLH332P025EH Datasheet(PDF) 2 Page - Cornell Dubilier Electronics |
|
AXLH332P025EH Datasheet(HTML) 2 Page - Cornell Dubilier Electronics |
2 / 5 page Load Life Test Test Mount the capacitor on a heat sink with a low thermal resistance path. Apply the maximum rated voltage for 2000 hrs at +150°C with the +150°C maximum ripple current applied to the capacitor. After the test, measure the capacitance, ESR, and DCL at +20°C. ∆C Capacitance will be within ±15% of the initial value ESR ESR will be less than 2 times the initial value DCL The leakage current will be within the specified value Appearance No electrolyte leakage or other visible damage. The markings will be legible. Vibration Test Surge Voltage Test Storage at Low Temperature Test Charge and Discharge Test Test Clamp the case to the test fixture. Frequency range is 10 - 2000 Hz. Amplitude of 1.5mm or 20 g acceleration. Duration of test is 22 hours in each of three directions. After the test, measure the capacitance at +20°C. ∆C Capacitance change from the initial measurement must not exceed 5%. Appearance No electrolyte leakage or other visible damage. Test Subject the capacitor to 1000 surge voltage cycles at +150°C. For each cycle, apply 1.15 times the rated voltage for 30 seconds followed by no voltage for 5 min. and 30 seconds. The time constant for charging is 0.1 seconds. After one to two hours, measure the capacitance and esr. ∆C Capacitance change from the initial measurement must not exceed 15%. ESR The ESR will be < 2x initial value. Appearance No electrolyte leakage or other visible damage. Test Subject the capacitor to 72 hours at -55°C. After 16 hours at room temperature, measure the capacitance and DCL. ∆C Capacitance change from the initial measurement must not exceed 10%. DCL Leakage current will meet the initial specification. Appearance No electrolyte leakage or other visible damage. The markings are to be legible. Test Subject the capacitor to 1 million charge/discharge cycles at +20°C. For each cycle, apply the rated voltage for 0.5 seconds using a 0.1 second charge/discharge time constant. After the test, the following will apply; ∆C Capacitance will be within ±10% of the initial value. Appearance No electrolyte leakage or other visible damage. Type AXLH -40 ºC to +150 ºC High Temperature Axial Leaded Aluminum Electrolytic Capacitors CDM Cornell Dubilier • 140 Technology Place • Liberty, SC 29657 • Phone: (864)843-2277 • Fax: (864)843-3800 |
Similar Part No. - AXLH332P025EH |
|
Similar Description - AXLH332P025EH |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.COM |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Datasheet Upload | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |