Electronic Components Datasheet Search |
|
LMV339MT Datasheet(PDF) 7 Page - National Semiconductor (TI) |
|
|
LMV339MT Datasheet(HTML) 7 Page - National Semiconductor (TI) |
7 / 21 page Application Circuits Basic Comparator A basic comparator circuit is used for converting analog sig- nals to a digital output. The LMV331/393/339 have an open-collector output stage, which requires a pull-up resistor to a positive supply voltage for the output to switch properly. When the internal output transistor is off, the output voltage will be pulled up to the external positive voltage. The output pull-up resistor should be chosen high enough so as to avoid excessive power dissipation yet low enough to supply enough drive to switch whatever load circuitry is used on the comparator output. On the LMV331/393/339 the pull-up resistor should range between 1k to 10k Ω. The comparator compares the input voltage (V in)atthe non-inverting pin to the reference voltage (V ref) at the invert- ing pin. If V in is less than Vref, the output voltage (Vo)isatthe saturation voltage. On the other hand, if V in is greater than V ref, the output voltage (Vo)isatVcc.. Comparator with Hysteresis The basic comparator configuration may oscillate or produce a noisy output if the applied differential input voltage is near the comparator’s offset voltage. This usually happens when the input signal is moving very slowly across the compara- tor’s switching threshold. This problem can be prevented by the addition of hysteresis or positive feedback. Inverting Comparator with Hysteresis The inverting comparator with hysteresis requires a three re- sistor network that are referenced to the supply voltage V cc of the comparator. When Vin at the inverting input is less than V a, the voltage at the non-inverting node of the com- parator (V in < Va), the output voltage is high (for simplicity assume V o switches as high as Vcc). The three network re- sistors can be represented as R 1//R3 in series with R2. The lower input trip voltage V a1 is defined as When V in is greater than Va (Vin Va), the output voltage is low very close to ground. In this case the three network re- sistors can be presented as R 2//R3 in series with R1. The up- per trip voltage V a2 is defined as The total hysteresis provided by the network is defined as ∆V a = Va1 -Va2 To assure that the comparator will always switch fully to V cc and not be pulled down by the load the resistors values should be chosen as follow: R pull-up << Rload and R 1 > Rpull-up. DS100080-26 DS100080-4 FIGURE 1. Basic Comparator www.national.com 7 |
Similar Part No. - LMV339MT |
|
Similar Description - LMV339MT |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.COM |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Datasheet Upload | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |