408--4571

Seating Tools 91318--[ ], 91319--[ ], and 91320--[ ]

3

of 3

Rev A

Tyco Electronics Corporation

5. MAINTENANCE AND INSPECTION

5.1. Initial Inspection

It is recommended that the seating tool be inspected

using Figure 3 immediately upon arrival in your facility

to ensure that it has not been damaged during

shipment.

5.2. Daily Maintenance

It is recommended that each operator be made aware

of, and responsible for, the following steps of daily

maintenance:

1. Remove dust, moisture, and other contaminants

with a clean, soft brush, or lint--free cloth. Do NOT

use objects that could damage the tool or any of its

components.

2. Ensure that the screws are in place and

secured.

3. When the tool is not in use, store it in a clean,

dry area.

5.3. Periodic Inspection

Regular inspections should be performed by quality

control personnel. A record of scheduled inspections

should remain with the tool or be supplied to

supervisory personnel responsible for the tool. The

inspection frequency should be based on the amount

of use, working conditions, operator training and skill,

and established company standards.

6. REPLACEMENT

The seating tool is not repairable. Order replacement

seating tools through your representative, or call

1--800--526--5142, or send a facsimile of your

purchase order to 1--717--986--7605 or write to:

CUSTOMER SERVICE (38--35)

TYCO ELECTRONICS CORPORATION

PO BOX 3608

HARRISBURG PA 17105--3608

A

B

C

SEATING TOOL

DIMENSION

SEATING TOOL

A

B

C

91318--1

23.88 [.940]

91318--2

47.75 [1.88]

44.45 [1.75]

26.97 [1.062]

91318--3

95.50 [3.76]

[

]

[

]

91319--1

24.89 [.980]

91319--2

49.78 [1.96]

38.10 [1.50]

25.40 [1.00]

91319--3

149.35[5.88]

[

]

[

]

91320--1

24.89 [.980]

91320--2

49.78 [1.96]

28.70 [1.13]

28.44 [1.12]

91320--3

248.92 [9.80]

[

]

[

]

Figure 3

7. REVISION SUMMARY

Revisions to this instruction sheet include:

S

Updated instruction sheet to corporate

requirements

S

Removed references to support anvil

S

Changed Paragraph 3.2

S

Replaced Step 7, added CAUTION, and added

NOTE to Section 4

S

Removed phone number for customer repair

service