MSD 6 Series

6A, PN 6200; 6AL, PN 6420; 6T, PN 6400;

6BTM, PN 6462; 6ALN, PN 6430

Parts Included:

1 - MSD 6 Series Ignition

1 - 100V/1A Diode

1 - Harness, PN 8860

4 - Wire Splicers

1 - Harness, PN 8861

2 - Wire Ties

1 - 18" Ground Wire

1 - Faston Receptacle

1 - White Jumper

2 - Faston Straight Terminals

1 - Red Jumper

4 - 45° Faston Terminals

6T, 6AL 6ALN, 6BTM, Only:

4 - #8 x 3/4" Screws

4 - Vibration Mounts and Hardware

2 - 10-32 x 1/2" Screws

4 - 10-32 Hex Nuts

6AL, 6ALN, Only:

6 - #10 Lock Washers

4 - RPM Modules, 3,000, 6,000, 7,000, 8,000

WARNING: During installation, disconnect the battery cables. When disconnecting the battery

always remove the Negative cable first and install it last.

Note: Solid Core spark plug wires cannot be used with an MSD Ignition.

Note: An MSD 6 Series cannot be used with distributorless ignition systems (DIS).

THEORY OF 6 SERIES IGNITION

CAPACITIVE DISCHARGE

The MSD 6 Series Ignitions feature a capacitive discharge ignition design. The majority of stock

ignition systems are inductive ignitions. In an inductive ignition, the coil must store and step up the

voltage to maximum strength in between each firing. At higher rpm, since there is less time to charge

the coil to full capacity, the voltage falls short of reaching maximum energy which results in a loss of

power or top end miss.

The MSD Ignition features a capacitor which is quickly charged (within one millisecond) with 460

- 480 volts and stores it until the ignition is triggered. With the CD design, the voltage sent to the coil

is always at full power even at high rpm.

MULTIPLE SPARKS

The MSD 6 Series produces full power multiple sparks for each firing of a plug. The number of

multiple sparks that occur decreases as rpm increases, however the spark series always lasts for 20°

of crankshaft rotation. Above 3,000 rpm there is simply not enough "time" to fire the spark plug more

than once, so there is only one powerful spark.

REV LIMITER

6AL, 6ALN, 6BTM: These ignitions are equipped with built-in Adjustable Soft Touch Rev Controls.

MSD Rev Limiters are adjustable with plug-in modules which are available in 100 rpm increments.

The Soft Touch circuitry provides a smooth and accurate rev limit by dropping the spark to individual

cylinders. The Soft Touch produces a load-free rev limit that is within 1% of the selected rpm.