Instruction Sheet

Extraction Tools 1804175- 1, 1804176- 1, and

1804177- 1 for Chicklets of Z- PACK*

408--10057

LOC B

1

of 2

E

2009 Tyco Electronics Corporation, Harrisburg, PA

All International Rights Reserved

TE logo and Tyco Electronics are trademarks.

*Trademark. Other products, logos, and company names used are the property of their respective owners.

TOOLING ASSISTANCE CENTER 1--800--722--1111

PRODUCT INFORMATION 1--800--522--6752

This controlled document is subject to change.

For latest revision and Regional Customer Service,

visit our website at www.tycoelectronics.com

10 SEP 09 Rev B

Hard Metric (HM)- Zd Right- Angle Headers

Insertion

Leg

Support

Leg

EXTRACTION TOOL

RIGHT--ANGLE HEADER

1804175--1

2--Pair

1804176--1

3--Pair

1804177--1

4--Pair

Figure 1

1. INTRODUCTION

The extraction tools listed in Figure 1 are designed to

remove individual chicklets of Z--PACK HM--Zd

right--angle headers from the printed circuit (pc)

board.

Reasons for reissue of this instruction sheet are

provided in Section 6, REVISION SUMMARY.

2. DESCRIPTION

Each extraction tool features an insertion leg with a

slot designed to straddle the row of contacts, and a

support leg that supports the back of the chicklet

during extraction.

3. EXTRACTION PROCEDURE

1. Refer to instruction sheet 408--10055, and

remove the housing from the pc board.

The housing of the right--angle header must be

removed from the pc board before the chicklets

can be removed.

2. Position the extraction tool over the chicklet to

be removed so that the support leg is aligned with

the back of the chicklet and the row of contacts will

enter the slot of the insertion leg. See Figure 2,

Detail A.

3. Press down evenly on the extraction tool until it

bottoms on the chicklet. Make sure that the row of

contacts enters the slot of the insertion leg.

4. Hold onto the pc board, and gently rock the

extraction tool toward the front of the chicklet,

creating interference (the chicklet will pivot out

slightly).

DO NOT try to pull the chicklet straight off of the

pc board; otherwise, the extraction tool will slip

off of the chicklet.

5. Continue to rock the extraction tool back--and--

forth until the chicklet lifts away from the pc board.

6. Discard the chicklet.

Figure 2

Press Down

Rock Extraction Tool Back--and--Forth

Detail A

Detail B

Back of

Chicklet

Slot of

Insertion Leg

Row of

Contacts

Insertion Tool

Bottomed on

Chicklet

PC Board

NOTE

i

NOTE

i