Instruction Sheet

©2012 Tyco Electronics Corporation, a TE Connectivity Ltd. Company

All Rights Reserved

*Trademark

TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.

1 of 6

TOOLING ASSISTANCE CENTER 1-800-722-1111

PRODUCT INFORMATION 1-800-522-6752

This controlled document is subject to change.

For latest revision and Regional Customer Service,

visit our website at www.te.com

LOC B

408-8739

PRO-CRIMPER* III Hand Crimping

Tool Assembly 91359-1 with

Die Assembly 91359-2

17 JAN 12 Rev B

PROPER USE GUIDELINES

Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use

and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.

† Supplied with Die Assembly; Also Available Separately

‡ Contact PRODUCT INFORMATION at the number at the bottom of this page for specific contact part numbers

Figure 1

1. INTRODUCTION

PRO-CRIMPER III Hand Tool Assembly 91359-1

consists of PRO-CRIMPER III Hand Tool Frame

354940-5 and Die Assembly 91359-2. The tool

assembly is used to crimp the contacts onto the wire

listed in Figure 1. Read these instructions thoroughly

before using the tool assembly.

For additional information on the hand tool frame, refer

to 408-9930.

Reasons for reissue of this instruction sheet are

provided in Section 8, REVISION SUMMARY.

Dimensions in this instruction sheet are in metric

units [with U.S. customary units in brackets].

Figures are not drawn to scale.

The tool consists of a tool frame with a stationary jaw,

stationary handle, moving jaw, and moving handle and

an adjustable ratchet that ensures full crimping. The

tool features a lower terminal support for supporting

the contact during crimping, and a ratchet adjustment

wheel for adjusting the crimp height.

Die Assembly

Moving Jaw

Ratchet Adjustment

Wheel

Stationary Jaw

Back of Tool Frame

(Wire Side)

Ratchet (Ref)

PRO-CRIMPER III Hand Tool

Frame 354940-5 (408-9930)

Stationary Handle

Moving Handle

The PRO-CRIMPER III Hand Crimping Tool is a “Commercial" grade tool and is designed

primarily for field installation, repair, maintenance work, or prototyping in industrial,

commercial, or institutional applications. Product crimped with this tool will meet the crimp

height requirement for hand tools in the appropriate Application Specification (114-series),

but may not comply with other feature parameters of the specification.

TE Connectivity offers a variety of tools to satisfy your performance requirements.

For additional information, contact the Tooling Assistance Center at 1-800-722-1111.

Lower Terminal Support

Locator Assembly

Pivot Pin

DIE ASSEMBLY

LOCATOR

ASSEMBLY †

PRODUCT FAMILY ‡

WIRE

Size

(AWG)

Maximum Insulation

Diameter (mm [in.])

Strip Length

(mm [in.])

91359-2

58515-1

Electronic Control

Unit (ECU)-11

Generation II

18

2.36 [.093]

5.7 [.22]

16

(Fluoropolymer)

2.62 [.103]

NOTE

i