408- 1632

7

of 11

Rev C

Figure 11

Inspection of Wire Barrel Section

of Crimping Chamber

Inspection of Insulation Barrel Section

of Crimping Chamber

Wire Barrel Crimping

Section of Dies Bottomed,

but Not Under Pressure

Adjustment Spacers

in Position 1

Insulation Barrel

Crimping Section

of Dies

Gage

Element

Wire Barrel Crimping

Section of Dies Bottomed,

But Not Under Pressure

Adjustment Spacers

in Position 3

“GO” Gage Must Pass Completely

Through Crimping Chamber

“NO--GO Gage May Enter Partially,

But Must Not Pass Completely

Through Crimping Chamber

“GO” Gage Must Pass Completely Through

Insulation Barrel Section of Crimping Chamber

“NO--GO Gage May Enter Partially, But Must Not

Pass Completely Through Insulation Barrel Section

of Crimping Chamber

Gage

Element

If the crimping chamber conforms to the gage

inspection, the dies may be considered dimensionally

correct and should be lubricated with a THIN coat of

any good SAE 20 motor oil. If the crimping chamber

DOES NOT conform to the gage inspection, the dies

must be returned for further evaluation and repair.

6. REPLACEMENT AND REPAIR

Customer--replaceable parts are listed in Figure 12.

A complete inventory should be stocked and

controlled to prevent lost time when replacement of

parts is necessary. Parts other than those listed

should be replaced by TE Connectivity to ensure

quality and reliability. Order replacement parts

through your representative, or call 1--800--526--5142,

or send a facsimile of your purchase order to

717--986--7605, or write to:

CUSTOMER SERVICE (038--035)

TYCO ELECTRONICS CORPORATION

PO BOX 3608

HARRISBURG PA 17105--3608

For customer repair service, call 1--800--526--5136.

7. REVISION SUMMARY

Revisions to this instruction sheet include:

S

Updated document to corporate requirements

S

New logo