Electronic Components Datasheet Search |
|
408-4291 Datasheet(PDF) 2 Page - Tyco Electronics |
|
408-4291 Datasheet(HTML) 2 Page - Tyco Electronics |
2 / 3 page 408-4291 PRO-CRIMPER III Hand Crimping Tool Assembly 58622-1 Rev A 2 of 3 Tyco Electronics Corporation Figure 2 Identical Upper and Lower Crimping Dies Tool Frame Die Retaining Screws 3. INSTALLATION AND REMOVAL OF DIE ASSEMBLY (Figure 2) 1. Open the tool handles and remove the two die retaining screws from the tool jaws. 2. Slide the die assembly into the partially opened tool jaws. 3. Insert the die retaining screws and tighten the screws just enough to hold the dies in place. Do not tighten the screws completely at this time. 4. Carefully close the tool handles, making sure the dies align properly. Continue closing the tool handles until the ratchet in the tool frame has engaged sufficiently to hold the die in place, then tighten both die retaining screws. 5. To disassemble, close the tool handles until the ratchet releases, remove the two die retaining screws, and slide the dies out of the tool jaws. 4. CRIMPING PROCEDURE 4.1. Connector Preparation 1. Strip cable according to the dimensions in the appropriate connector instruction sheet. 2. Assemble connector to cable per procedure stated on instruction sheet. 4.2. Connector Crimp 1. See appropriate connector instruction sheet. 2. Place connector in bottom half of die assembly so that the shoulder on the connector is approximately 3.18 [.125] from end of die. See Figure 3. 3. Holding the assembly in place, close the tool handles until the ratchet releases. 4. Remove the crimped assembly from the crimping die. 5. INSPECTION 5.1. Visual Inspection Inspection of the crimping dies should be made on a regular basis to ensure that they have not become worn or damaged. Inspect the crimp sections for flattened, chipped, worn, or broken areas. If damage or abnormal wear is evident, the dies must be replaced. Refer to Section 7, REPLACEMENT. Figure 3 Connector Placement in Dies Connector Approximately 3.18 [.125] From End of Die Crimping Ferrule |
Similar Part No. - 408-4291 |
|
Similar Description - 408-4291 |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.COM |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Datasheet Upload | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |