MC78L00A Series, NCV78L00A

www.onsemi.com

2

Figure 2. Standard Application

A common ground is required between the input and the output voltages. The input voltage must remain typically 2.0 V above the output

voltage even during the low point on the input ripple voltage.

MC78LXXA

Input

0.33

mF

0.1

mF

Output

ABSOLUTE MAXIMUM RATINGS

Rating

Symbol

Value

Unit

Input Voltage (5.0 V−9.0 V)

30

35

40

Vdc

Storage Temperature Range

−65 to +150

°C

Maximum Junction Temperature

150

°C

Moisture Sensitivity Level

MSL

1

−

ESD Capability, Human Body Model (Note 1)

2000

V

ESD Capability, Machine Model (Note 1)

200

V

ESD Capability, Charged Device Model (Note 1)

2000

V

Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality

should not be assumed, damage may occur and reliability may be affected.

1. This device series incorporates ESD protection and is tested by the following methods:

ESD Human Body Model tested per AEC−Q100−002 (EIA/JESD22−A114)

ESD Machine Model tested per AEC−Q100−003 (EIA/JESD22−A115)

ESD Charged Device Model tested per EIA/JES D22/C101, Field Induced Charge Model.

THERMAL CHARACTERISTICS

Rating

Symbol

Value

Unit

Package Dissipation

PD

Internally Limited

W

Thermal Characteristics, TO−92

Thermal Resistance, Junction−to−Ambient

200

°C/W

Thermal Characteristics, SOIC8

Thermal Resistance, Junction−to−Ambient

Refer to Figure 8

°C/W

Thermal Characteristics, SOT−89

Thermal Resistance, Junction−to−Ambient

55

°C/W

2. Thermal Resistance, Junction−to−Ambient depends on P.C.B. Copper area. See details in Figure 8.

Thermal Resistance, Junction−to−Case is not defined. SOIC 8 lead and TO-92 packages that do not have a heat sink like other packages

may have. This is the reason that a Theta JC is never specified. A little heat transfer will occur through the package but since it is plastic, it is

minimal. The majority of the heat that is transferred is through the leads where they connect to the circuit board.