ADS7890

SLAS409 − DECEMBER 2003

www.ti.com

9

Power Down

Phase

12

3

4

5

PWD/RST

BUSY

SDO

td6

tw4

First 4 Invalid Conversions

Valid Conversions

RESET Phase

Invalid Data

Valid Data

td7

Figure 3. Device Power Down

PWD/RST

BUSY

SDO

tw3

First 4 Invalid Conversions

Valid Conversions

RESET Phase

Invalid Data

Valid Data

td7

Figure 4. Device Reset

FRAME ABORT

A frame can be aborted at any time. There are three phases in the frame, data frame before sample start (first

8 clocks), sample phase (9th rising edge to the 16th falling edge of SCLK), and the conversion phase. The

following sections describe a frame abort during each of these phases, for both SPI and DSP interfaces.

FRAME ABORT IN SPI INTERFACE MODE (FS Held High)

The rising edge of CS after a frame start (falling edge of CS) before the 9th rising edge of SCLK aborts a frame

(see Figure 5). SDO goes to three-state with CS high. A new frame is started with the falling edge of CS.

Previous conversion results are available on SDO during the new frame.

D13

D12

D6

MSB-D13

LSB-D0

2

3

89

23

15

16

Data From Last Conversion

SCLK

CS

BUSY

SDO

Figure 5. Frame Abort Before Sample Start

aborts the sample and the device enters the conversion phase. As expected, SDO goes to three-state with CS

high. The conversion results can be latched in the next frame, however reliability of the data depends on the

sampling time available before the frame abort.