RPM7200-Hx series

Photo Link Module

5/6

T1

T2

T1

≠T2

(5) The receiver was designed to use as in-door use only.

Therefore, please understand that the receiver cannot cover all characteristics, in case of using it out-door.

(6) Noise environment (Light noise from inverter Lamp, and other kind of Lamps, Power ripple, electromagnetic noise from

power circuit, and etc) may cause a reduced effective distance.

(7) The receiver may not work properly if receiving signal judgement is done by single pulse due to the

surrounding / environmental noises.

To prevent such misjudgement, please make sure that the receiver is set up to work only when receiving

series of coded signal.

(8) Emitting unit (remote control transmitter) has to be considered about its emitting device function, characteristics and

characteristics of the receiver.

(9) Please connect ‘Holder’ on to the ‘Ground (GND)’ of PCB. If the holder is not connected to the GND, there is a

possibility of worsening the characteristics of product.

(10) Do not supply unnecessary stress to lead and holder.

(11) Please pay careful attention to the lens.

It might have a chance to miss-function when the lens get dust or dirty. And also please do not touch the lens.

(12) In order to prevent products from ESD, human body and solder iron, etc. are required to be grounded.