6

sAssembly Instructions(3-Position Plug)

q

Straight Plug

Outer case

Outer case

Outer case

Outer case

q

Right Angle Plug

Insulator body

Insulator body

Outer case

1. Slide the bushing over the cable.

2. Prepare the cable end and the conductors as shown.

3. Crimp the contacts to each conductor.

Verify the crimp dimensions.

4. Insert each of the contacts into the insulator body.

Verify that the contact is secure by slightly pulling

on the conductor. Should the contacts require re-

insertion, use the tool RP6-SC-TP to remove them

(Inserted from the termination side).

5. Crimp the cable clamp over the cable at designated

dimension (Tool number:RP34-TC-01).

6. Place the outer case on a flat surface , with inside facing up.

7. Carefully place the insulator body, clamp and the bushing

into corresponding indents and cut-outs in the outer case.

Verify correct location. (As shown on drawing)

Note A: When placing all components in the case,

exercise caution as NOT to damage any of the

protruding snap.

Note B: All components should fit easily, without use of

any force.

8. Carefully align the other outer case over all

components case. Do not force alignment.

9. Snap the case in place.

1. The right angle plug can also be assembled by

using the same procedure as the straight plug.