CRCW.... EN802

www.vishay.com

Vishay Draloric

Revision: 01-Sep-15

4

Document Number: 28806

THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT

DESCRIPTION

Production follows a set of instructions established for

reproducibility. A thick film layer and a glass-over are

prepared inner contacts. The target value is achieved by

laser cutting an L shaped groove in the resistive layer. The

resistor elements are covered by a protective coating

designed for electrical, mechanical and climatic protection.

The terminations receive a final pure tin on nickel plating. A

four-character code marking designates the resistance

The result of the determined production is verified by an

extensive testing procedure performed on 100 % of the

individual resistors. Only accepted products are placed into

ASSEMBLY

The resistors are suitable for processing on automatic SMD

assembly systems. They are suitable for automatic

soldering using wave, reflow or vapour phase as shown in

. Solderability is specified for 2 years after

production.

The resistors are lead (Pb)-free, the pure tin plating provides

compatibility with both, lead (Pb)-free and tin lead (SnPb)

based soldering processes. The immunity of the plating

against tin whisker growth has been proven under extensive

testing.

The encapsulation is resistant to all cleaning solvents

commonly used in the electronics industry, including

alcohols, esters and aqueous solutions. The suitability of

conformal

coatings,

potting

compounds,

and

their

processes, if applied, shall be qualified by appropriate

means to ensure the long-term stability of the whole system.

MATERIALS

Vishay acknowledges the following systems for the

regulation of hazardous substances:

• IEC 62474, Material Declaration for Products of and for the

Electrotechnical Industry, with the list of declarable

• The

Global

Automotive

Declarable

Substance

List

• The REACH regulation (1907/2006/EC) and the related list

supply chain

The products do not contain any of the banned substances

as per IEC 62474, GADSL, or the SVHC list, see

Hence the products fully comply with the following

directives:

• 2000/53/EC End-of-Life Vehicle Directive (ELV) and

Annex II (ELV II)

• 2011/65/EU

Restriction

of

the

Use

of

Hazardous

Substances

Directive

(RoHS)

with

amendment

2015/863/EU

• 2012/19/EU Waste Electrical and Electronic Equipment

Directive (WEEE)

Vishay pursues the elimination of conflict minerals from its

supply

chain,

see

the

Conflict

Minerals

Policy

at

APPROVALS

The resistors are approved within the IECQ-CECC Quality

Assessment System for Electronic Components to the detail

specification EN 140401-802 which refers to EN 60115-1,

EN 60115-8

and

the

variety

of

environmental

test

Conformity is attested by the use of the CECC logo (

) as

the Mark of Conformity on the package label.

The Vishay Draloric production facility is registered with the

CAGE code SH903.

RELATED PRODUCTS

A parallel family of lead (Pb)-bearing thick film chip resistors

with CECC approval, available with established reliability, is

available, see datasheet:

• “D.. EN802 - Lead (Pb)-Bearing Thick Film Chip Resistors

with

CECC

Approval,

Available

with

Established

Reliability”

A wider range of product sizes, TCR, tolerance and

resistance values, plus the option of values from a different

E series is available without approval to any EN specification

(quality factor

• “D/CRCW e3 - Standard Thick Film Chip Resistors”

• “D/CRCW - Lead (Pb)-Bearing Thick Film, Rectangular

Chip Resistors”

Notes