Figure 5. Current Transfer Ratio vs.

Input Current.

Figure 6. Propagation Delay vs.

Forward Current.

Figure 7. Propagation Delay vs.

Temperature.

Notes:

1. Derate linearly above 50

°C free-air

temperature at a rate of 0.4 mA/

°C.

2. Derate linearly above 50

°C free-air

temperature at a rate of 0.7 mW/

°C.

3. Derate linearly above 25

°C free-air

temperature at a rate of 0.8 mA/

°C.

4. Derate linearly above 25

°C free-air

temperature at a rate of 1.5 mW/

°C.

5. DC CURRENT TRANSFER RATIO is

defined as the ratio of output

6. Pin 6 Open.

Package Characteristics

For 0

°C ≤ T

Parameter

Symbol

Min.

Typ.

Max. Units

Test Conditions

Fig.

Notes

Input-Output Momentary

2500

V rms

RH

≤ 50%, t = 1 min,

7, 10

Withstand Voltage*

Resistance, Input-Output

Ω

7

Capacitance, Input-Output

0.6

pF

f = 1 MHz

7

*The Input-Output Momentary Withstand Voltage is a dielectric voltage rating that should not be interpreted as an input-output

continuous voltage rating. For the continuous voltage rating refer to the VDE 0884 Insulation Characteristics Table (if applicable),

your equipment level safety specification, or HP Application Note 1074, “Optocoupler Input-Output Endurance Voltage.”

maximum tolerable (negative)

assure that the output will remain in

10. In accordance with UL 1577, each

optocoupler is proof tested by

applying an insulation test voltage

≥ 3000 V rms for 1 second (leakage

7. Device considered a two-terminal

device: Pins 1, 2, 3 shorted together

and Pins 4, 5, and 6 shorted together.

8. Use of a resistor between pin 4 and 6

will decrease gain and delay time.

(See Figures 11, 12, and 13.)

9. Common mode transient immunity in

Logic High level is the maximum

leading edge of the common mode

will remain in a Logic High state (i.e.,

immunity in Logic Low level is the

Figure 2. Input Diode Forward

Current vs. Forward Voltage.

Figure 3. Typical DC Transfer

Characteristics.

Figure 4. Output Current vs. Input

Current.

1-438