7

E3FZ/E3FR

Specification

Item

Background suppression (BGS)

E3FZ-LS

@1H / E3FR-LS@1H

E3FZ-LS

@6H / E3FR-LS@6H

E3FZ-LS

@4H / E3FR-LS@4H

E3FZ-LS

@9H / E3FR-LS@9H

Sensing distance

10 to 100 mm (White paper 100x100 mm)

10 to 200 mm (White paper 100x100 mm)

Spot diameter

4 mm dia. at sensing distance of 100 mm

18 mm dia. at sensing distance of 200 mm

Standard sensing object

–

Differential travel

3% of sensing distance max.

20% of sensing distance max.

Black/white error

5% of sensing distance max.

20% of sensing distance max.

Directional angle

–

Light source (wave length)

Red LED (650 nm)

Red LED (660 nm)

Power supply voltage

10 to 30 VDC, including 10% ripple(p-p)

Current consumption

25 mA max.

Control output

Load power supply voltage; 30 VDC max., Load current; 100 mA max. (Residual voltage; 2 V max.),

Light-on/Dark-on selectable by wire,

E3F

@-LS6: NPN open-collector output

E3F

@-LS8: PNP open-collector output

Protective circuits

Power supply reverse polarity protection, output short-circuit protection,

mutual interference prevention and reversed output polarity protection

Response time

Operate and reset; 1 ms max.

Sensitivity adjustment

–

Ambient illumination

(receiver side)

Incandescent lamp; 3000 lx max., Sunlight 10000 lx max.

Ambient temperature

Operating; -25 to +55°C, Storage; -40 to +70°C (with no icing or condensation)

Ambient humidity

Operating; 35 to 85%RH, Storage; 35 to 95%RH (with no condensation)

Insulation resistance

20M

Ω min. at 500 VDC

Dielectric resistance

1000 VAC at 50/60 Hz for 1 min

Vibration resistance

Destruction; 10 to 55 Hz, 1.5 mm double amplitude for 2 hours, each in X, Y and Z directions

Shock resistance

*1.

The IP69k test according to DIN 40 050 part 9 is intended to simulate high pressure/steam cleaning. During the test 14-16 l/min water

at 80ºC is sprayed onto the sensor from different angles with 8000-10000 kPa. The sensor may not suffer any damaging effects from

high pressure water in appearance and functionality.

IEC 60529 IP67, IP69K after DIN 40050-9

Connection method

Pre-wired cable (standard length 2m), Standard M12 connector

Indicator

Operation indicator: yellow, stability indicator: green

Weight

(packed state)

Pre-wired

approx.60g

Standard

connector

approx.20g

Material

Case

ABS

Cover-lens

Plate-window

PMMA

Accessories

Instruction sheet, 2x M18 nuts, snap mounting tool (E3FZ only).

E55E-EN-01+E3FZ-E3FR+Datasheet.FM Seite 7 Dienstag, 15. April 2008 5:17 17