The main digital acquisition mode on the MSO3000 Series will capture up

to 5 Mpoints at 500 MS/s (2 ns resolution). In addition to the main record,

the MSO3000 provides an ultra high-resolution record called MagniVu

which acquires 10,000 points at up to 8.25 GS/s (121.2 ps resolution). Both

main and MagniVu waveforms are acquired on every trigger and can be

switched between in the display at any time, running or stopped. MagniVu

provides significantly finer timing resolution than comparable MSOs on the

market, instilling confidence when making critical timing measurements on

digital waveforms.

The MagniVu high-resolution record provides 121.2 ps timing resolution, enabling you to

take critical timing measurements on your digital waveforms.

P6316 MSO probe

This unique probe design offers two eight-channel pods, simplifying the

process of connecting to the device-under-test. When connecting to square

pins, the P6316 can connect directly to 8×2 square pin headers spaced on

tenth-inch centers. When more attachment flexibility is required, you can

use the included flying lead sets and grabbers to clip onto surface mount

devices or test points. The P6316 offers outstanding electrical

characteristics applying only 8 pF of capacitive loading with 101 kΩ input

impedance.

The P6316 MSO probe offers two eight-channel pods to simplify connecting to your

device.

Serial triggering and analysis (optional)

On a serial bus, a single signal often includes address, control, data, and

clock information. This can make isolating events of interest difficult.

Automatic trigger, decode, and search on bus events and conditions gives

you a robust set of tools for debugging serial buses.

clock and the blue waveform is the data. A bus waveform provides decoded packet

content including Start, Address, Read/Write, Data, and Stop.

Serial triggering

Trigger on packet content such as start of packet, specific addresses,

specific data content, unique identifiers, etc. on popular serial interfaces

Bus display

Provides a higher-level, combined view of the individual signals (clock,

data, chip enable, etc.) that make up your bus, making it easy to identify

where packets begin and end and identifying sub-packet components such

as address, data, identifier, CRC, etc.

Bus decoding

Tired of having to visually inspect the waveform to count clocks, determine

if each bit is a 1 or a 0, combine bits into bytes, and determine the hex

value? Let the oscilloscope do it for you! Once you’ve set up a bus, the

MSO/DPO3000 Series will decode each packet on the bus, and display the

value in hex, binary, decimal (LIN, FlexRay, and MIL-STD-1553 only),

RS-232/422/485/UART only) in the bus waveform.

Datasheet

6 www.tektronix.com