Sheet No.: D2-A04102EN

■ Manufacturing Guidelines

● Soldering Method

Flow Soldering :

Due to SHARP's double transfer mold construction submersion in flow solder bath is allowed under the below

listed guidelines.

Flow soldering should be completed below 270˚C and within 10s.

Preheating is within the bounds of 100 to 150˚C and 30 to 80s.

Please don't solder more than twice.

Hand soldering

Hand soldering should be completed within 3s when the point of solder iron is below 400˚C.

Please don't solder more than twice.

Other notices

Please test the soldering method in actual condition and make sure the soldering works fine, since the impact

on the junction between the device and PCB varies depending on the tooling and soldering conditions.

10

PC714VxNSZXF Series