408-1559

Hand Crimping Tools

9 of 10

Rev P

Tyco Electronics Corporation

Figure 10

GO" element must pass completely

through the die closure.

NO-GO" element may

enter partially, but must not pass

completely through the die closure.

Detail A

Inspection of Wire Barrel Crimping Dies

Detail B

Inspection of Insulation Crimping Dies

Wire Barrel

Jaws Bottomed

But Not Under

Pressure

Adjustment

Pins in No. 1

Position

4. Check the clearance between the bottoming

surfaces of the crimping dies. If the clearance is

.025 mm [.001 in.] or less, the ratchet is

satisfactory. If clearance exceeds .025 mm

[.001 in.], the ratchet is out of adjustment, and

must be repaired. Refer to Section 8,

REPLACEMENT AND REPAIR. If the tool

conforms to these inspection procedures, lubricate

it with a THIN coat of any good SAE 20 motor oil

and return it to service.

8. REPLACEMENT AND REPAIR

Replacement parts are listed in Figure 11. Parts other

than those listed in Figure 11 should be replaced by

Tyco Electronics to ensure quality and reliability of the

tool. Order replacement parts through your Tyco

Electronics Representative, or call 1–800–526–5142,

or send a facsimile of your purchase order to

1–717–986–7605, or write to:

CUSTOMER SERVICE (38–35)

TYCO ELECTRONICS CORPORATION

P.O. BOX 3608

HARRISBURG, PA 17105–3608

For tool repair service, please contact a

representative at 1–800–526–5136.

9. REVISION SUMMARY

Since the previous release of this sheet, the following

changes were made:

Figures 1, 3, 8, 9, and 11