Electronic Components Datasheet Search
  English  ▼

Delete All
ON OFF
ALLDATASHEET.COM

X  

Preview PDF Download HTML

AD53500 Datasheet(PDF) 3 Page - Analog Devices

Part No. AD53500
Description  High Speed, High Current Capability Pin Driver
Download  7 Pages
Scroll/Zoom Zoom In 100% Zoom Out
Maker  AD [Analog Devices]
Homepage  http://www.analog.com
Logo 

AD53500 Datasheet(HTML) 3 Page - Analog Devices

   
Zoom Inzoom in Zoom Outzoom out
 3 / 7 page
background image
–3–
REV. 0
AD53500
CAUTION
ESD (electrostatic discharge) sensitive device. Electrostatic charges as high as 4000 V readily
accumulate on the human body and test equipment and can discharge without detection.
Although the AD53500 features proprietary ESD protection circuitry, permanent damage may
occur on devices subjected to high energy electrostatic discharges. Therefore, proper ESD
precautions are recommended to avoid performance degradation or loss of functionality.
Parameter
Min
Typ
Max
Units
Test Conditions
DYNAMIC PERFORMANCE, INHIBIT
Delay Time, Active to Inhibit
2
10
ns
Measured at 50%, VH = +2 V,
VL = –2 V, 50 Ω Terminated to Ground
Delay Time, Inhibit to Active
2
10
ns
Measured at 50%, VH = +2 V,
VL = –2 V, 50 Ω Terminated to Ground
I/O Spike
<200
mV, p-p
VH = 0 V, VL = 0 V
Output Leakage
–1.0
+1.0
µAV
OUT = –2 V to +6 V
Output Capacitance
18
pF
Driver Inhibited
PSRR, Drive Mode
35
dB
VS = VS ± 3%
POWER SUPPLIES
Total Supply Range
16
V
Positive Supply
+10
V
Negative Supply
–6
V
Positive Supply Current
85
95
mA
Negative Supply Current
88
98
mA
Total Power Dissipation
1.37
1.54
W
Temperature Sensor Gain Factor
1.0
µA/K
RLOAD = 10 kΩ, VSOURCE = +10 V
NOTES
Connecting or shorting the decoupling capacitors to ground will result in the destruction of the device.
Specifications subject to change without notice.
ABSOLUTE MAXIMUM RATINGS
1
Power Supply Voltage
+VS to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +11 V
–VS to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –7 V
+VS to –VS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +18 V
Inputs
DATA,
DATA, INH, INH . . . . . . . . . . . . . . . . +5 V, –3 V
DATA to
DATA, INH to INH
. . . . . . . . . . . . . . . .
±3 V
VH, VL to GND . . . . . . . . . . . . . . . . . . . . . . . . . +7 V, –3 V
VH to VL
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +10 V, 0 V
Outputs
VOUT Short Circuit Duration to Ground . . . . . . . Indefinite
2
VOUT Range in Inhibit Mode . . . . . . . . . . . . . See Figure 1
VHDCPL . . . . . . . . Do Not Connect Except for Cap to VCC
3
VLDCPL . . . . . . . . . Do Not Connect Except for Cap to VEE
3
THERM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +VS, 0 V
Environmental
Operating Temperature (Junction) . . . . . . . . . . . . . . +175
°C
Storage Temperature . . . . . . . . . . . . . . . . –65
°C to +150°C
Lead Temperature (Soldering, 10 sec)
4
. . . . . . . . . . +260
°C
NOTES
1Stresses above those listed under Absolute Maximum Ratings may cause perma-
nent damage to the device. This is a stress rating only; functional operation of the
device at these or any other conditions above those indicated in the operational
sections of this specification is not implied. Absolute maximum limits apply
individually, not in combination. Exposure to absolute maximum rating conditions
for extended periods may affect device reliability.
2Output short circuit protection is guaranteed as long as proper heat sinking is
employed to ensure compliance with the operating temperature limits.
3The V
HDCPL and VLDCPL capacitors may be replaced by a low value resistor for higher
dc-current drive capability.
4To ensure lead coplanarity (
±0.002 inches) and solderability, handling with bare
hands should be avoided and the device should be stored in environments at 24
°C
± 5°C (75°F ± 10°F) with relative humidity not to exceed 65%.
WARNING!
ESD SENSITIVE DEVICE
1
23
4
5
–1
1
–1
–2
2
3
4
5
6
VH, VL
VOUT
VOUT = (MIN) = –3V
FIGURE 1 SHOWS THE MAXIMUM ALLOWABLE LIMITS FOR VOUT AS A FUNCTION
OF VHIGH AND VLOW WHEN THE DRIVER IS OPERATING IN INHIBIT MODE. THE
LIMITS, AS STATED BEFORE, ARE MAXIMUM RATINGS ONLY, AND SHOULD NOT
BE USED AS THE PART'S NORMAL OPERATING RANGE. THIS RANGE APPLIES
ONLY TO SUPPLIES OF +VS = +10V AND –VS = –6V AND SHOULD BE DERATED
PROPORTIONALLY FOR LOWER SUPPLIES.
VHIGH / VLOW
VOUT = (MAX) = +7V
–2
6
–3
7
Figure 1. Absolute Maximum Ratings for VOUT


Html Pages

1  2  3  4  5  6  7 


Datasheet Download




Link URL




Privacy Policy
ALLDATASHEET.COM
Does ALLDATASHEET help your business so far?  [ DONATE ]  

About Alldatasheet   |   Advertisement   |   Datasheet Upload   |   Contact us   |   Privacy Policy   |   Alldatasheet API   |   Link Exchange   |   Manufacturer List
All Rights Reserved© Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn