MCT-8200 Hand Crimp Tool

Doc. No: ATS-640013900

Release Date: 09-26-03

UNCONTROLLED COPY

Page 9 of 9

Revision: K

Revision Date: 05-06-08

Certificate of Calibration

Tool Order Number ____________________________

Tool Eng. Number_____________________________

Tool Revision________________________________

Serial Number_______________________________

Date of Manufacture___________________________

Handle Load Range; see Tool Preload (page 6). =______________

Actual =_______________

Pin Gauge of Conductor Nest/Nests or Slug height if the nest is the “F” Crimp style.

Range Conductor Nest # 1 =______________Actual =_____________

Range Conductor Nest # 2 =______________Actual =_____________

Range Conductor Nest # 3 =______________Actual =_____________

Range Conductor Nest # 4 =______________Actual =_____________

Technician________________________

Date of Calibration ___________________

Calibration should be done every 5,000 cycles or 3 months.

Tools should be lubricated during this operation.

Americas Headquarters

Lisle, Illinois 60532 U.S.A.

1-800-78MOLEX

amerinfo@molex.com

Far East North Headquarters

Yamato, Kanagawa, Japan

81-462-65-2324

feninfo@molex.com

Far East South Headquarters

Jurong, Singapore

65-6-268-6868

fesinfo@molex.com

European Headquarters

Munich, Germany

49-89-413092-0

eurinfo@molex.com

Corporate Headquarters

2222 Wellington Ct.

Lisle, IL 60532 U.S.A.

630-969-4550

Fax: 630-969-1352

Visit our Web site at http://www.molex.com