UM10206

© Koninklijke Philips Electronics N.V. 2006. All rights reserved.

User manual

Rev. 01 — 13 June 2006

8 of 12

Philips Semiconductors

UM10206

I2C Demonstration Board 2005-1 Quick Start Guide

7.

Starting Win-I2CUSB Lite

When you have correctly installed the software and the Demonstration Board Hardware is

connected and recognized by the computer, start the Win-I2CUSB Lite software (see

Figure 4).

the computer recognizes it, the message “Hardware Detected” is displayed.

or by double clicking on the 3.3 V or 5.0 V symbols on the lower side of the main

window. Power supplies are disabled by default and you must enable them before

the frequency symbol in the lower side of the main window.

are highlighted in the menu.

Universal Modes” allows you to send

8 lines of command in the Lite version of the software. Each line of command can

have up to 9 bytes of data.

Fig 4.

Win-I2CUSB Lite main window

Switched power

indicators

I

Device selection

(devices not supported in Lite

version are dimmed)

Access to the Expert Mode that allows

writing specific I

Board Self Test Routine

Hardware detection message