Electronic Components Datasheet Search |
|
62500-2823 Datasheet(PDF) 9 Page - Molex Electronics Ltd. |
|
62500-2823 Datasheet(HTML) 9 Page - Molex Electronics Ltd. |
9 / 39 page Hawk Discrete Wire Termination Machine Order No TM-011200949 Release Date: 02-16-97 UNCONTROLLED COPY Page 9 of 39 Revision: D Revision Date: 03-03-11 THUMB SCREW SHIFT KNOB Figure 2-3 Figure 2-1 ADJUSTMENT KNOB THUMB SCREW FINE ADJUST Figure 2-2 Set Up 2.1 Air Pressure Set the air pressure regulator on the air inlet to 5 - 6 BAR (80 - 90 PSI). This is done by pulling out the adjustment knob and setting to the proper pressure, then pushing in the knob. See Figure 2-1. 2.2 Connector Feed Adjustment Shuttle Stop The shuttle stop is adjustable from 3 to 25 circuits. 1. To adjust the stop, loosen the thumb screw on top of the cartridge holder. This holds and locates the cylinder stop on the bottom side. Starting from “3” circuit to the left, each notch represents 1 circuit position on the shuttle. The left side of the connector must always go to the left end of the termination anvil when fed in. 2. Move the stop to the correct circuit size. 3. Tighten the thumb screw. Note: 2 circuit connectors are loaded in pairs stop is set for 4 circuits. Connector Feed Stop This stop is also adjustable from 3 to 25 circuits. To adjust the stop: 1. Remove the nest guard. 2. Loosen the thumb screw on the connector feed stop located in front of the shift nest. 3. Starting from “3” circuits to the right, stop locates on every circuit position to 25 circuits. Adjust so that only 1 connector (except 2-2 circuits.) at a time can enter the shift nest from the cartridge feed. 4. When adjustment is set, tighten thumb screw. 5. Replace guard. See Figure 2-3. 2.3 Shuttle Fine Adjustment With a connector in the nest and the shuttle full forward against the stop, the first terminal should be centered on the terminal punch. Due to tolerance variations in connector lengths, it may be necessary to occasionally make a fine adjustment to the shuttle. To adjust the shuttle: 1. Load a connector into the termination head in manual mode. 2. With the shuttle blade in the forward position, loosen the cap screws at the rear of the shuttle adjustment base. |
Similar Part No. - 62500-2823 |
|
Similar Description - 62500-2823 |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.COM |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Datasheet Upload | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |