SPEC No.

LCY-12T09303B

MODEL No.

LS013B4DN02

PAGE

2

[For handling and system design]

(1) Handle with care as glass is used in this LCD panel. Dropping or contact against hard object may cause cracks or

chips.

(2) Do not scratch the surface of the UV protection film as it is easily damaged.

(3) Water droplets on the UV protection film must be wiped off immediately as they may cause color changes, or other

defects if remained for a long time.

(4) To clean LCD panel surface, wipe clean with absorbent cotton or soft cloth. If further cleaning is needed, use IPA

(isopropyl alcohol) and wipe clean lightly on surface only. Do not use organic solvents as it may damage the LCD

panel terminal area which uses organic material. Also, do not directly touch with finger.

(5) To avoid circuit failure, do not touch panel terminal area.

(6) Do not expose gate driver, etc. on the panel (circuit area outside panel display area) to light as it may not operate

properly. Design that shields gate driver, etc. from light is required when mounting the LCD module.

(7) Support for the LCD panel should be carefully designed to avoid stress that exceeds specification on glass surface.

(8) Panel is susceptible to mechanical stress and such stress may affect the display. Place the panel on flat surface

to avoid stress caused by twist, bend, etc..

(9) When transporting LCD panels, secure them in LCD panel tray to avoid mechanical stress. The tray should be

conductive to protect LCD panels from static charge.

Material used in set or epoxy resin (amine type hardening agent) from packaging, and silicon adhesive

(dealcoholized or oxime) all release gas which may affect quality of UV protection film. Do confirm compatibility with

user materials.

(10) Do not use chloroprene rubber as it generates chlorine gas and affects reliability in LCD panel connective area.

(11) This LCD module is sensitive to electrostatic discharge of 200V or more. Handle with care using cautions for

the followings:

Operators

Operators must wear anti-static wears to prevent electrostatic charge up to and discharge from human

body.

Equipment and containers

Process equipment such as conveyer, soldering iron, working bench and containers may possibly generate

electrostatic charge up and discharge. Equipment must be grounded through 100Mohms resistance. Use

ion blower.

Floor

Floor plays an important role in leaking static electricity generated in human body or equipment. If the floor

is made of insulated material (such as polymer or rubber material), such static electricity may charge.

Proper measure should be taken to avoid static electricity charge (electrostatic earth: 100Mohms).There is

a possibility that the static electricity is charged to them without leakage in case of insulating floor, so the

electrostatic earth:1×10