LifecyclePhase:

Revision

: 1

Expired Period: Forever

Release Date:2009-05-11 22:09:23.0

EVERLIGHT ELECTRONICS CO.,LTD.

Technical Data Sheet

Side View Red SMD LEDs

57-21/R6C-AP1Q2B/BF

Everlight Electronics Co., Ltd.

http://www.everlight.com

Rev. 1

Page:9 of 10

Device No. : DSE-0000692

Prepared date:05-Jan-2009

Prepared by: Ryan Chen

Precautions For Use

1. Over-current-proof

Customer must apply resistors for protection, otherwise slight voltage shift will cause big

current change ( Burn out will happen ).

2. Storage

2.1 Do not open moisture proof bag before the products are ready to use.

2.2 Before opening the package: The LEDs should be kept at 30℃ or less and 90%RH or less.

2.3 After opening the package: The LED's floor life is 48 hours under 30

or less and 60% RH or less. If

℃

unused LEDs remain, it should be stored in moisture proof packages.

2.4 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the

storage time, baking treatment should be performed using the following conditions.

Baking treatment : 60±5℃ for 24 hours.

3. Soldering Condition

3.1 Pb-free solder temperature profile

3.2 Reflow soldering should not be done more than two times.

3.3 When soldering, do not put stress on the LEDs during heating.

3.4 After soldering, do not warp the circuit board.

120 Sec. Max.

1~5 °C / Sec.

Pre-heating

180~200°C

60 Sec. Max.

Above 220°C

260°C. Max.

10 Sec. Max.

1~5 °C / Sec.