52500

HEATER, 18V, 9W, FACTORY SET TEMPERATURE

Micropac Industries cannot assume any responsibility for any circuits shown or represent that they are free from patent infringement.

Micropac reserves the right to make changes at any time in order to improve design and to supply the best product possible.

MICROPAC INDUSTRIES, INC. MICROCIRCUITS DIVISION

• 905 E. Walnut St., Garland, TX 75040 • (972) 272-3571 • Fax (972) 494-2281

www.micropac.com

1 April 2009 Rev -

Pg. 2 of 2

Figure 1 Case Outline X (Shown With Lead Wires)

Table 3 Ordering Information

Part Number

Case Outline

Termination

52500-SP-TTT

X

Solder Pad

52500-LW-TTT

X

Lead Wires

Where TTT corresponds to 3 digit temperature set point (from 050 to 100°C).

SCREENING

All 52500 heaters receive the following MIL-STD-883 screening:

•

Precap internal visual Method 2017, Condition B

•

Temperature cycling, Method 1010, Condition B

•

Constant acceleration, Method 2001, Condition B, Y axis only

•

Fine and Gross leak test, Method 1014, Conditions A & C

•

External visual, Method 2009