![]() |
Electronic Components Datasheet Search |
|
OPA2335M Datasheet(PDF) 2 Page - Burr-Brown (TI) |
|
|
OPA2335M Datasheet(HTML) 2 Page - Burr-Brown (TI) |
2 / 16 page ![]() www.ti.com PIN CONFIGURATIONS P0037-01 1 2 3 4 8 7 6 5 OutB V+ +InB -InB -In A Out A +In A V- OPA2335 CDIP A B ABSOLUTE MAXIMUM RATINGS (1) ELECTRICAL CHARACTERISTICS OPA2335M SGLS320 – SEPTEMBER 2006 This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with appropriate precautions. Failure to observe proper handling and installation procedures can cause damage. ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be more susceptible to damage because very small parametric changes could cause the device not to meet its published specifications. PACKAGE/ORDERING INFORMATION SPECIFIED PACKAGE PACKAGE PACKAGE ORDERING PRODUCT TEMPERATURE LEAD DESIGNATOR MARKING NUMBER RANGE OPA2335 CDIP-8 JG –55 °C to 125°C OPA2335AMJG OPA2335AMJG over operating free-air temperature range (unless otherwise noted) VALUE UNIT Supply voltage 7 V Voltage(2) –0.5 to (V+) + 0.5 V Signal input terminals Current(2) ±10 mA Output short circuit(3) Continuous Operating temperature TA –55 to 150 °C Storage temperature TA –65 to 150 °C Junction temperature 150 °C Lead temperature (soldering, 10s) 300 °C (1) Stresses above these ratings may cause permanent damage. Exposure to absolute maximum conditions for extended periods may degrade device reliability. These are stress ratings only, and functional operation of the device at these, or any other conditions beyond those specified, is not implied. (2) Input terminals are diode-clamped to the power-supply rails. Input signals that can swing more than 0.5 V beyond the supply rails should be current-limited to 10 mA or less. (3) Short-circuit to ground, one amplifier per package At T A = 25°C, VS = +5 V, RL = 10 kΩ connected to VS/2, and VOUT = VS/2 (unless otherwise noted) PARAMETER TEST CONDITIONS MIN TYP MAX UNIT OFFSET VOLTAGE Input offset voltage VOS VCM = VS/2 TA = 25°C 1 5 µV TA = Full 10 range vs Temperature dVOS/dT ±0.02 µV/°C 2 Submit Documentation Feedback |