MPB125 Multiple-Output AC-DC Series Data Sheet

OCT 24, 2005 revised to JUN 05, 2006

Page 4 of 9

www.power-one.com

Environmental Specifications

PARAMETER

CONDITIONS/DESCRIPTION

MIN

NOM

MAX

UNITS

Altitude

Operating

10K

ASL Feet

Non-Operating

50K

Operating Temperature

Derate linearly from 50 to 70°C to 50% power at 70°C.

At 100% load:

0

50

°C

MPB125 models will operate at -20°C, but will not meet all specifications.

Storage Temperature

-40

85

°C

Forced-Air Cooling

1

Forced-air cooling of 5 CFM is required for full output power except for

MPB125-2003 and -2003D. Air velocity is measured with power supply mounted on

0.375" (9.5mm) standoffs. Airflow direction is from the input section to

the output section. See Application Note #M3 for details.

Temperature Coefficient

Included in total regulation of outputs.

Relative Humidity

Non-Condensing.

5

95

%RH

Shock

Operating: 11 ±3ms, 3 axes, Half Sine.

15

Gpk

Non-operating: 11 ±3ms, 3 axes, Half Sine.

40

Vibration

Operating:

Random vibration, 5-500 Hz, 10 minutes each axis.

2.4

Non-Operating: Random vibration, 5-500 Hz, 10 minutes each axis.

6.0

Options

DESCRIPTION

NOTES

Remote On/Off

Remote On/Off is a TTL-comatible signal. A logic “high” or open circuit turns the unit on. Reverse inhibit logic can be achieved

Standby Output

by changing the position of the J6 connector. A logic “low” inhibits all outputs except the 5V standby. At remote off, the Power

(Option R)

Good signal will warn the host equipment 2 milliseconds before the main output goes out of regulation. The rating of the

standby output is +5V @ 0.2 Amps. Total regulation is ±5 %. Maximum noise and ripple is 50 mV peak-to-peak @ a 20 MHz

bandwidth.

NOTE: The addition of Option “R” increases the supply width from 3.0 to 3.8 inches. Consult factory for availability.

NOTES:

25A with a minimum airflow of 5 CFM.

Ordering Information:

OPTIONS

SUFFIXES TO ADD TO PART NUMBER

RoHS lead solder exempt 1

No RoHS suffix character required.

RoHS compliant for all 6 substances

Add “G” as the last character of the part number.

1 The solder exemption refers to all the restricted materials except lead in solder.