1.8V-3.3V PicoPLL

47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 12/12/06 Page 3

FUNCTIONAL DESCRIPTION

PL611s-02 is a highly featured, very flexible, advanced programmable PLL design for high performance, low-

power, small form-factor applications. The PL611s-02 accepts a fundamental input crystal of 10MHz to 50MHz or

reference clock input of 1MHz to 200MHz and is capable of producing two outputs up to 200MHz. This flexible

PLL Programming

The PLL in the PL611s-02 is fully programmable.

The PLL is equipped with an 8-bit input frequency

divider (R-Counter), and an 11-bit VCO frequency

feedback loop divider (M-Counter). The output of

the PLL is transferred to a 5-bit post VCO divider (P-

Counter). The output frequency is determined by

Clock Output (CLK0)

CLK0 is the main clock output. The output of CLK0

The output drive level can be programmed to Low

Drive (4mA), Standard Drive (8mA) or High Drive

(16mA). The maximum output frequency is

determined by the Power Supply Voltage; 200MHz at

3.3V, 166MHz at 2.5V and 133MHz at 1.8V.

Clock Output (CLK1)

The CLK1 feature allows the PL611s-02 to have an

additional clock output programmed to one of the

following:

CLK0

CLK0 / 2

Output Enable (OE)

The Output Enable feature allows the user to enable

and disable the clock output(s) by toggling the OE

pin. The OE pin incorporates a 60k

pull up

resistor giving a default condition of logic “1”.

Power-Down Control (PDB)

The Power Down (PDB) feature allows the user to

put the PL611s-02 into “Sleep Mode”. When

activated (logic ‘0’), PDB ‘Disables the PLL, the

oscillator circuitry, counters, and all other active

circuitry. In Power Down mode the IC consumes

<10 A of power. The PDB pin incorporates a 60k

pull up resistor giving a default condition of logic “1”.

Frequency Select (FSEL)

The Frequency Select (FSEL) feature allows the

PL611s-02 to switch between two pre-programmed

outputs allowing the device “On the Fly” frequency

switching. The FSEL pin incorporates a 60k

pull

up resistor giving a default condition of logic “1”.