Electronic Components Datasheet Search
  English  ▼

Delete All
ON OFF
ALLDATASHEET.COM

X  

Preview PDF Download HTML

GM6156 Datasheet(PDF) 5 Page - Gamma Microelectronics Inc.

Part No. GM6156
Description  150mA LOW-NOISE LDO REGULATOR
Download  9 Pages
Scroll/Zoom Zoom In 100% Zoom Out
Maker  GAMMA [Gamma Microelectronics Inc.]
Homepage  http://www.gammamicro.com.tw/
Logo 

GM6156 Datasheet(HTML) 5 Page - Gamma Microelectronics Inc.

   
Zoom Inzoom in Zoom Outzoom out
 5 / 9 page
background image
5
Applications Information
Enable/ Shutdown
Forcing EN (enable/ shutdown) high (>2V) enables the regulator. EN is compatible with CMOS logic gates. If
enable shutdown feature is not required, connect EN (pin 1) to IN (supply input, pin 5). See Figure 3.
Input Capacitor
A 1µF capacitor should be placed from IN to GND if there is more than 10 inches of wire between the input
and the ac filter capacitor or if a battery is used as the input .
Reference Bypass Capacitor
BYP (reference bypass) is connected to the internal voltage reference. A 470pF capacitor (C
) connected
BYP
from BYP to GND quiets this reference, providing a significant reduction in output noise. C
reduces the
BYP
regulator phase margin. When using C
, output capacitors of 2.2µF or greater are generally required to
BYP
maintain stability.
The start-up speed of GM6156 is inversely proportional to the size of the reference bypass capacitor.
Applications requiring a slow ramp-up of output voltage should consider larger values of C
. Likewise, if
BYP
rapid turn-on is necessary, consider omitting C
.
BYP
If output noise is not a major concern, omit C
and leave BYP open.
BYP
Output Capacitor
An output capacitor is required between OUT and GND to prevent oscillation. The minimum size of the output
capacitor is dependent upon whether a reference bypass capacitor is used. 1.0µF minimum is recommended
when C
is not used (see Figure 2). 2.2µF minimum is recommended when C
is 470pF (see Figure 1).
BYP
BYP
Larger values improve the regulator's transient response, the output capacitor value may be increased
without limit.
The output capacitor should have an ESR (effective series resistance) of about 5W or less and a resonant
frequency above 1MHz. Ultra-low-ESR capacitors can cause a low amplitude oscillation on the output and/
or underdamped transient response. Most tantalum or aluminum electrolytic capacitors are adequate; film
types will work, but are more expensive. Since many aluminum electrolytics have electrolytes that freeze at
about -30°C, solid tantalums ate recommended for operation below -25°C.
At lower values for output current, less output capacitance is required for output stability. The capacitor can
be reduced to 0.47µF for current below 10mA or 0.33µF for current below 1mA.
No-Load Stability
GM6156 will remain stable and in regulation with no load (other than the internal voltage divider) unlike many
other voltage regulators. This is especially important in CMOS RAM keep-alive applications.
Thermal Considerations
GM6156 is designed to provide 150mA of continuous current in a very small package. Maximum power
dissipation can be calculated based on the output current and the voltage drop across the part. To determine
the maximum power dissipation of the package, use the junction-to-ambient thermal resistance of the device
and the following basic equation:
T
is the maximum junction temperature of the die, 125°C, and TA is the ambient operating temperature.
J(max)
R
is layout dependent; Table 1 shows examples of junction-to-ambient thermal resistance for the GM6156.
JA
q
P
=
D(max)
(T
- T )
J(max)
A
R
qJA


Html Pages

1  2  3  4  5  6  7  8  9 


Datasheet Download



Related Electronics Part Number

Part NumberComponents DescriptionHtml ViewManufacturer
GM6155150mA LOW-NOISE LDO REGULATOR 1 2 3 4 5 MoreGamma Microelectronics Inc.
BD3951FSystem Regulator RESET Vcc-Detection and 150mA LDO 1 2 3 4 5 MoreRohm
GM6155150mA LOW - NOISE LDO REGULATOR 1 2 3 4 5 MoreList of Unclassifed Manufacturers
LTC1705Dual 550kHz Synchronous Switching Regulator Controller with 5-Bit VID and 150mA LDO 1 2 3 4 5 MoreLinear Technology
LR1102LOW NOISE 150mA LDO REGULATOR 1 2 3 4 5 MoreUnisonic Technologies
AAT3201150mA OmniPower™ LDO Linear Regulator 1 2 3 4 5 MoreAdvanced Analog Technology, Inc.
AAT3220150mA NanoPower™ LDO Linear Regulator 1 2 3 4 5 MoreAdvanced Analog Technology, Inc.
AAT3221150mA NanoPower™ LDO Linear Regulator 1 2 3 4 5 MoreAdvanced Analog Technology, Inc.
ISL6412_07Triple Output Low-Noise LDO Regulator with Integrated Reset Circuit 1 2 3 4 5 MoreIntersil Corporation
MM3081JL150mA CMOS Regulator 1 2 Mitsumi Electronics, Corp.

Link URL




Privacy Policy
ALLDATASHEET.COM
Does ALLDATASHEET help your business so far?  [ DONATE ]  

About Alldatasheet   |   Advertisement   |   Datasheet Upload   |   Contact us   |   Privacy Policy   |   Alldatasheet API   |   Link Exchange   |   Manufacturer List
All Rights Reserved© Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn