Electronic Components Datasheet Search
  English  ▼

Delete All
ON OFF
ALLDATASHEET.COM

X  

Preview PDF HTML

ZL30409 Datasheet(PDF) 3 Page - Zarlink Semiconductor Inc

Part No. ZL30409
Description  T1/E1 System Synchronizer with Stratum 3 Holdover
Download  32 Pages
Scroll/Zoom Zoom In 100% Zoom Out
Maker  ZARLINK [Zarlink Semiconductor Inc]
Homepage  http://www.zarlink.com
Logo 

ZL30409 Datasheet(HTML) 3 Page - Zarlink Semiconductor Inc

 
Zoom Inzoom in Zoom Outzoom out
 3 / 32 page
background image
ZL30409
Data Sheet
3
Zarlink Semiconductor Inc.
Pin Description
Pin #
Name
Description
1,10,
23,31
GND
Ground. 0 Volts.
2RST
Reset (Input). A logic low at this input resets the ZL30409. To ensure proper operation, the
device must be reset after reference signal frequency changes and power-up. The RST pin
should be held low for a minimum of 300 ns. While the RST pin is low, all frame pulses except
RSP and TSP and all clock outputs except C6o, C16o and C19o are at logic high. The RSP,
TSP, C6o, C16o are at logic low during reset. The C19o is free-running during reset. Following
a reset, the input reference source and output clocks and frame pulses are phase aligned as
shown in Figure 13.
3TCLR
TIE Circuit Reset (Input). A logic low at this input resets the Time Interval Error (TIE)
correction circuit resulting in a realignment of input phase with output phase as shown in
Figure 13. The TCLR pin should be held low for a minimum of 300 ns. This pin is internally
pulled down to GND.
4IC
Internal Connection. Leave unconnected.
5
SEC
Secondary Reference (Input).
This is one of two (PRI & SEC) input reference sources
(falling edge) used for synchronization. One of four possible frequencies (8 kHz, 1.544 MHz,
2.048 MHz or 19.44 MHz) may be used. The selection of the input reference is based upon
the MS1, MS2, RSEL, and PCCi control inputs.This pin is internally pulled up to VDD.
6PRI
Primary Reference (Input). See SEC pin description. This pin is internally pulled up to VDD.
7,17
28,35
VDD
Positive Supply Voltage. +3.3VDC nominal.
8OSCo
Oscillator Master Clock (CMOS Output).
For crystal operation, a 20 MHz crystal is
connected from this pin to OSCi, see Figure 9. Not suitable for driving other devices. For clock
oscillator operation, this pin is left unconnected, see Figure 8.
9OSCi
Oscillator Master Clock (CMOS Input). For crystal operation, a 20 MHz crystal is
connected from this pin to OSCo, see Figure 9. For clock oscillator operation, this pin is
connected to a clock source, see Figure 8.
11
F16o
Frame Pulse ST-BUS 8.192 Mb/s (CMOS Output). This is an 8 kHz 61ns active low framing
pulse, which marks the beginning of an ST-BUS frame. This is typically used for ST-BUS
operation at 8.192 Mb/s. See Figure 14.
12
F0o
Frame Pulse ST-BUS 2.048 Mb/s (CMOS Output). This is an 8 kHz 244 ns active low
framing pulse, which marks the beginning of an ST-BUS frame. This is typically used for ST-
BUS operation at 2.048 Mb/s and 4.096 Mb/s. See Figure 14.
13
RSP
Receive Sync Pulse (CMOS Output). This is an 8 kHz 488 ns active high framing pulse,
which marks the beginning of an ST-BUS frame. This is typically used for connection to the
Siemens MUNICH-32 device. See Figure 15.
14
TSP
Transmit Sync Pulse (CMOS Output). This is an 8 kHz 488 ns active high framing pulse,
which marks the beginning of an ST-BUS frame. This is typically used for connection to the
Siemens MUNICH-32 device. See Figure 15.
15
F8o
Frame Pulse (CMOS Output). This is an 8 kHz 122 ns active high framing pulse, which
marks the beginning of a frame. See Figure 14.
16
C1.5o
Clock 1.544 MHz (CMOS Output). This output is used in T1 applications.


Html Pages

1  2  3  4  5  6  7  8  9  10  11  12  13  14  15  16  17  18  19  20  21  22  23  24  25  26  27  28  29  30  31  32 


Datasheet Download




Link URL




Privacy Policy
ALLDATASHEET.COM
Does ALLDATASHEET help your business so far?  [ DONATE ]  

About Alldatasheet   |   Advertisement   |   Datasheet Upload   |   Contact us   |   Privacy Policy   |   Alldatasheet API   |   Link Exchange   |   Manufacturer List
All Rights Reserved© Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn