LP3963/LP3966

3A Fast Ultra Low Dropout Linear Regulators

General Description

The LP3963/LP3966 series of fast ultra low-dropout linear

regulators operate from a +2.5V to +7.0V input supply. Wide

range of preset output voltage options are available. These

ultra low dropout linear regulators respond very quickly to

step changes in load which makes them suitable for low

voltage microprocessor applications. The LP3963/LP3966

are developed on a CMOS process which allows low quies-

cent current operation independent of output load current.

This CMOS process also allows the LP3963/LP3966 to op-

erate under extremely low dropout conditions.

Dropout Voltage: Ultra low dropout voltage; typically 80mV

at 300mA load current and 800mV at 3A load current.

Ground Pin Current: Typically 6mA at 3A load current.

Shutdown Mode: Typically 15µA quiescent current when

the shutdown pin is pulled low.

Error Flag: Error flag goes low when the output voltage

drops 10% below nominal value (for LP3963).

SENSE: Sense pin improves regulation at remote loads.

(For LP3966)

Precision Output Voltage: Multiple output voltage options

are available ranging from 1.2V to 5.0V and adjustable

load, and temperature).

Features

n

Ultra low dropout voltage

n

Low ground pin current

n

Load regulation of 0.06%

n

15µA quiescent current in shutdown mode

n

Guaranteed output current of 3A DC

n

Available in TO-263 and TO-220 packages

n

n

Error flag indicates output status (LP3963)

n

Sense option improves load regulation (LP3966)

n

Minimum output capacitor requirements

n

Overtemperature/overcurrent protection

n

−40˚C to +125˚C junction temperature range

Applications

n

Microprocessor power supplies

n

GTL, GTL+, BTL, and SSTL bus terminators

n

Power supplies for DSPs

n

SCSI terminator

n

Post regulators

n

High efficiency linear regulators

n

Battery chargers

n

Other battery powered applications

Typical Application Circuits

10126701

*SD and ERROR pins must be pulled high through a 10k

Ω pull-up resistor. Connect the ERROR pin to ground if this function is not used. See applications

section for more information.

** See Application Hints

May 2003

© 2003 National Semiconductor Corporation

DS101267

www.national.com