![]() |
Electronic Components Datasheet Search |
|
PI3A4626 Datasheet(PDF) 2 Page - Pericom Semiconductor Corporation |
|
PI3A4626 Datasheet(HTML) 2 Page - Pericom Semiconductor Corporation |
2 / 8 page ![]() PI3A4626 3.0V, SOTiny™ Single-Supply 0.4Ω SPST (NO) CMOS Analog Switch 2 PS8714A 06/27/04 Absolute Maximum Ratings Voltages Referenced to GND VCC ......................................................................–0.5V to +3.6V VIN, VCOM, VNC, VNO (1)............................ –0.5V to VCC +0.3V or 30mA, whichever occurs first Current (any terminal).....................................................±200mA Peak Current, COM, NO, NC (Pulsed at 1ms, 10% duty cycle).....................................±400mA Note: 1. Signals on NC, NO, COM, or IN exceeding VCC or GND are clamped by internal diodes. Limit forward diode current to 30mA. Caution: Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the device at these or any other conditions beyond those indicated in the operational sections of this specification is not implied. Thermal Information Continuous Power Dissipation SOT-23 (derate 7.1mW/ºC above +70ºC)........................... 0.5W Storage Temperature ........................................–65ºC to +150ºC Lead Temperature (soldering, 10s) ................................. +300ºC Electrical Specifications - Single +3.3V Supply (VCC = +3.3V ± 10%, GND = 0V, VIH = 1.4V, VIL = 0.5V) Description Parameters Test Conditions Package Temp.(°C) Min.(1) Typ.(2) Max.(1) Units Analog Switch Analog Signal Range(3) VANALOG Full 0 VCC V On Resistance RON VCC = 2.7V, ICOM = 100mA, VNO or VNC = +1.5V 25 0.4 Ω SOT23 Full 0.5 TDFN 0.6 On-Resistance Match Between Channels(4) ∆RON 25 0.05 Full 0.06 On-Resistance Flatness(5) RFLAT(ON) VCC =2.7V ICOM = 100mA, VNO or VNC =0.8V, 2.0V 25 0.1 Full 0.1 NO or NC Off Leakage Current(6) ICOM(OFF) or INC(OFF) VCC =3.3V, VCOM = 0V,VNO or VNC = +2.0V 25 –1 1 nA Full –20 10 COM On Leakage Cur- rent(6) ICOM(ON) VCC =3.3V, VCOM = +2.0V, VNO or VNC = + 2.0V 25 –2 2 Full –20 20 |