PREMILINARY
CY7C1302DV25
Document #: 38-05625 Rev. **
Page 5 of 18
Truth Table[2, 3, 4, 5, 6, 7]
Operation
K
RPS
WPS
DQ
DQ
Write Cycle:
Load address on the rising edge of K clock; input write
data on K and K rising edges.
L-H
X
L
D(A+0)at
K(t)
↑
D(A+1) at
K(t)
↑
Read Cycle:
Load address on the rising edge of K clock; wait one
cycle; read data on 2 consecutive C and C rising edges.
L-H
L
X
Q(A+0) at
C(t+1)
↑
Q(A+1) at
C(t+1)
↑
NOP: No Operation
L-H
H
H
D = X
Q = High-Z
D = X
Q = High-Z
Standby: Clock Stopped
Stopped
X
X
Previous
State
Previous
State
Write Cycle Descriptions[2,8]
BWS0
BWS1
KK
Comments
L
L
L-H
–
During the Data portion of a Write sequence, both bytes (D[17:0]) are written into the device.
L
L
–
L-H
During the Data portion of a Write sequence, both bytes (D[17:0]) are written into the device.
L
H
L-H
–
During the Data portion of a Write sequence, only the lower byte (D[8:0]) is written into the
device. D[17:9] remains unaltered.
L
H
–
L-H
During the Data portion of a Write sequence, only the lower byte (D[8:0]) is written into the
device. D[17:9] remains unaltered.
H
L
L-H
–
During the Data portion of a Write sequence, only the byte (D[17:9]) is written into the device.
D[8:0] remains unaltered.
H
L
–
L-H
During the Data portion of a Write sequence, only the byte (D[17:9]) is written into the device.
D[8:0] remains unaltered.
H
H
L-H
–
No data is written into the device during this portion of a Write operation.
H
H
–
L-H
No data is written into the device during this portion of a Write operation.
Notes:
2. X = Don't Care, H = Logic HIGH, L = Logic LOW,
↑ represents rising edge.
3. Device will power-up deselected and the outputs in a three-state condition.
4. “A” represents address location latched by the devices when transaction was initiated. A+0, A+1 represent the addresses sequence in the burst.
5. “t” represents the cycle at which a Read/Write operation is started. t+1 is the first clock cycle succeeding the “t” clock cycle.
6. Data inputs are registered at K and K rising edges. Data outputs are delivered on C and C rising edges, except when in single clock mode.
7. It is recommended that K = K and C = C when clock is stopped. This is not essential, but permits most rapid restart by overcoming transmission line charging
symmetrically. 38-05625
8. Assumes a Write cycle was initiated per the Write Port Cycle Description Truth Table. BWS0, BWS1 can be altered on different portions of a Write cycle, as long
as the set-up and hold requirements are achieved. 38-05625
English ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
