LPC2368 datasheet(2/48 Pages) PHILIPS

Part #	LPC2368

Description	Single-chip 16-bit/32-bit microcontrollers; up to 512 kB flash with ISP/IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC/DAC

Download	48 Pages

Scroll/Zoom	100%

Manufacturer	PHILIPS [NXP Semiconductors]

Direct Link	http://www.nxp.com

Logo

2 / 48 page

LPC2364_66_68_1

Preliminary data sheet

Rev. 01 — 22 September 2006

2 of 48

Philips Semiconductors

LPC2364/2366/2368

Fast communication chip

Ethernet MAC with associated DMA controller. These functions reside on an

independent AHB bus.

USB 2.0 Full-Speed Device with on-chip PHY and associated DMA controller.

Four UARTs with fractional baud rate generation, one with modem control I/O, one

with IrDA support, all with FIFO.

CAN controller with two channels.

SPI controller.

Two SSP controllers, with FIFO and multi-protocol capabilities. One is an alternate

for the SPI port, sharing its interrupt and pins. These can be used with the GPDMA

controller.

Three I2C-bus interfaces (one with open-drain and two with standard port pins).

I2S (Inter-IC Sound) interface for digital audio input or output. It can be used with

the GPDMA.

Other Peripherals:

Secure Digital (SD) / MultiMediaCard (MMC) memory card interface (LPC2368

only).

70 General purpose I/O pins with configurable pull-up/down resistors.

10-bit ADC with input multiplexing among 6 pins.

10-bit DAC.

Four general purpose Timers/Counters with total of 8 capture inputs and 10

compare outputs. Each Timer block has an external count input.

One PWM / Timer block with support for three-phase motor control. The PWM has

two external count inputs.

Real Time Clock with separate power pin, clock source can be the RTC oscillator or

the APB clock.

2 kB SRAM powered from the RTC power pin, allowing data to be stored when the

rest of the chip is powered off.

Watchdog Timer. The watchdog timer can be clocked from the internal RC

oscillator, the RTC oscillator, or the APB clock.

Standard ARM Test/Debug interface for compatibility with existing tools.

Emulation Trace Module supports real-time trace.

Single 3.3 V power supply (3.0 V to 3.6 V).

Four reduced power modes, Idle, Sleep, Power Down, and Deep Power down.

Four external interrupt inputs configurable as edge/level sensitive. All pins on PORT0

and PORT2 can be used as edge sensitive interrupt sources.

Processor wake-up from Power-down mode via any interrupt able to operate during

Power-down mode (includes external interrupts, RTC interrupt, USB activity, Ethernet

wake-up interrupt).

Two independent power domains allow fine tuning of power consumption based on

needed features.

Each peripheral has its own clock divider for further power saving.

Brownout detect with separate thresholds for interrupt and forced reset.

On-chip Power On Reset.

On-chip crystal oscillator with an operating range of 1 MHz to 24 MHz.

4 MHz internal RC oscillator trimmed to 1 % accuracy that can optionally be used as

the system clock. When used as the CPU clock, does not allow CAN and USB to run.

Similar Part No. - LPC2368

Manufacturer	Part #	Datasheet	Description
NXP Semiconductors	LPC2368	225Kb / 47P	Single-chip 16-bit/32-bit microcontrollers; up to 512 kB flash with ISP/IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC/DAC Rev. 02-1 October 2007
	LPC2368	983Kb / 59P	Single-chip 16-bit/32-bit microcontrollers; up to 512 kB flash with ISP/IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC/DAC Rev. 06-1 February 2010
	LPC2368	4Mb / 12P	NXP Microcontrollers Selection Guide November 2012
	LPC2368	405Kb / 69P	Single-chip 16-bit/32-bit ocontrollers; up to 512 kB flash with ISP/IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC/DAC Rev. 7.1-16 October 2013
	LPC2368	405Kb / 69P	Single-chip 16-bit/32-bit ocontrollers; up to 512 kB flash with ISP/IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC/DAC Rev. 7.1-16 October 2013

More results

Similar Description - LPC2368

Manufacturer	Part #	Datasheet	Description
NXP Semiconductors	LPC2364	225Kb / 47P	Single-chip 16-bit/32-bit microcontrollers; up to 512 kB flash with ISP/IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC/DAC Rev. 02-1 October 2007
	LPC2364	983Kb / 59P	Single-chip 16-bit/32-bit microcontrollers; up to 512 kB flash with ISP/IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC/DAC Rev. 06-1 February 2010
	LPC2378	253Kb / 54P	Single-chip 16-bit/32-bit microcontrollers; 512 kB flash with ISP/IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC/DAC Rev. 01-6 December 2006
	LPC2377	351Kb / 69P	Single-chip 16-bit/32-bit microcontrollers; 512 kB flash with ISP/IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC/DAC Rev. 6.1??6 October 2013
	LPC2387	1Mb / 47P	Single-chip 16-bit/32-bit microcontrollers; 512 kB flash with ISP/IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC/DAC Rev.01.00-6 November 2007
	LPC2387	226Kb / 47P	Single-chip 16-bit/32-bit microcontrollers; 512 kB flash with ISP/IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC/DAC Rev. 02-1 February 2008
	LPC2365FBD100	405Kb / 69P	Single-chip 16-bit/32-bit ocontrollers; up to 512 kB flash with ISP/IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC/DAC Rev. 7.1-16 October 2013
	LPC2364FET100	405Kb / 69P	Single-chip 16-bit/32-bit ocontrollers; up to 512 kB flash with ISP/IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC/DAC Rev. 7.1-16 October 2013
	LPC2377	258Kb / 55P	Single-chip 16-bit/32-bit microcontroller; 512 kB flash with ISP/IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC/DAC Rev. 04-19 November 2008
	LPC2377	1Mb / 68P	Single-chip 16-bit/32-bit microcontrollers; 512 kB flash withISP/IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC/DAC Rev. 5-17 June 2010

More results

LPC2368 Datasheet(PDF) 2 Page - NXP Semiconductors

LPC2368 Datasheet(HTML) 2 Page - NXP Semiconductors

Similar Part No. - LPC2368

Similar Description - LPC2368

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

Datasheet Download

Link URL