MODEL

B7-3

PIN-001

DESCRIPTION

Interpoint’s side-leaded packages can now be adapted with PIN

terminal adapters to fit a variety of configurations. These versatile

adapters slide over the ends of side-leaded package terminals and

are intended to be soldered to the leads to provide an up-leaded or

down-leaded configuration.

PIN adapters are constructed from low resistance copper alloy Cu-

70210 which has a conductivity similar to that of copper. The plating

is 50 microinches (0.12mm) of solder — 60% tin and 40% lead —

over 100 to 200 microinches (2.5 to 5mm) of electrolytic nickel

plating.

Low resistance copper alloy construction minimizes the voltage drop

across the PIN terminals. For example, when operating the

MFL2805S at full load (10 A) the voltage drop over the full length of

the adapter on positive Vout is just 30 mV. On single output

converter models, the sense function can compensate for even this

small drop if required.

To prevent unwanted solder reflow, Interpoint suggests the use of

SN 96 (high-temp solder) to connect the PIN to the converter

terminal and SN 62 to connect the PIN to the board. The soldering

restrictions referenced on the data sheets of the listed Interpoint

products are 300°C for a maximum of 10 seconds per terminal.

PIN terminal adapters are compatible with the following Interpoint

products:

MFL Series DC/DC converters

MFLHP Series DC/DC converters

MHP Series DC/DC converters

FMD-461SL, side-leaded DC/DC converter

LCM Line Conditioning Module

HUM-70 Hold-Up Module

PIN

PIN

ADAPTOR

• Adapts Interpoint “U1” cases

to upleaded or downleaded

configurations

• For use with MFL, MFLHP, MHP,

FMD270, HUM-70, or LCM Series

of Interpoint products

• Low resistance

• Copper alloy with solder plating

over nickel

PIN-001 adaptor dimensions are on the following page.