587B062LPE

thru

587B302LPE

1

05064.R4 12/03

www.protekdevices.com

LOW PROFILE 240V AC POWER LINE SURGE SUPPRESSOR

Only One Name Means ProTek’Tion™

APPLICATIONS

✔ Hard Wired Equipment AC Power Protection

✔ Load Side Distribution Systems

✔ Secondary Protection for Light Industrial AC Power

IEC COMPATIBILITY (EN61000-4)

✔ 61000-4-5 (Surge): 1kA, 8/20µs - Level 4(Line-Line)

FEATURES

✔ Meets ANSI/IEEE C62.41 Outdoor Requirements

✔ Listed to CSA, File LR65240 (Except 587B302LPE)

✔ Differential Mode Protection

✔ Low Clamping Voltage

✔ Nanosecond Response Time

✔ Long Life and Maintenance Free

✔ Finger Safe Connectors

MECHANICAL CHARACTERISTICS

✔ Plastic Package

✔ Weight: 360 Grams (Approximate)

✔ Flammability Rating UL 94V-0

✔ Device Marking: Part Number, Date Code, Logo, Voltage and Current Rating

DESCRIPTION

The 587B Low Profile (LPE) Series is designed for European applications where no

line to ground or neutral to ground suppression is allowed. These modules employ a

three stage technology proven to be the most cost effective and reliable method in

protecting sensitive electronic equipment from over voltage transients.

This series is designed to protect AC powered equipment from the 6,000 Volt peak

open circuit voltage and 3,000 Amp short circuit current as defined in ANSI/IEEE

C62.41, Category CI.

The 587BxxxLPE Series offers a high degree of protection against 240 VAC EMI line

noise. It is ideal for protecting 800 Volt components because the solid state TVS

technology assures that the line-to-neutral voltage will not exceed 800 Volts. While

the modules are designed for transient voltage protection, the advanced circuitry will

also attenuate the amplitude and slow the rate of rise of high frequency noise acting

as an EMI filter. The 587BxxxLPE Series includes common mode protection, which

are effective in reducing interference from line to equipment and are effective in

reducing equipment generated noise to meet FCC, VDE and CSA interference

requirements.

U.S PATENT 4,563,720

0

10

20

30

40

50

60

FIGURE 2

TYPICAL CLAMPING ACTION

OF A 15 AMP MODULE

0

10

20

30

40

50

60

Time - µs

0

2

6

4

FIGURE 1

TRANSIENT VOLTAGE THREAT

CONDITION

Time - µs

0

2

4

8

6

Figures 1 and 2 are photographs of digitized waveforms

showing the typical clamping action of a 16 ampere module.

A 12 Ohm resistor is used to represent a 10 Amp equipment

load. The load is then subjected to the ANSI/IEEE C62.41

Category CI test conditions (6,000V/3,000A). These photo-

graphs contrast the effect on equipment with and without the

protector.