MODEL: M6NPA

M6NPA SPECIFICATIONS

ES-7904 Rev.9 Page 1/4

http://www.m-system.co.jp/

Screw Terminal Ultra-Slim Signal Conditioners M6N Series

FREQUENCY TRANSMITTER

Functions & Features

• 7.5-mm wide ultra-slim design

• Low profile allows the M6N module mounted in a 120-mm

deep panel

• Converts the output from a pulse-type transducer into a

standard process signal

• High-density mounting

• Power indicator LED

mm (inch)

7.5 (.30)

102

(4.02)

102

(4.02)

MODEL: M6NPA–[1][2]–R[3]

ORDERING INFORMATION

• Code number: M6NPA-[1][2]-R[3]

Specify a code from below for each [1] through [3].

(e.g. M6NPA-CA-R/UL/Q)

• Frequency range (e.g. 0 – 1 kHz)

• Special output range (For codes Z & 0)

• Specify the specification for option code /Q

(e.g. /C01)

[1] INPUT

A1: Open collector

A2: Mechanical contact

C: 5 V pulse (sensitivity 2 V)

D: 24 V pulse (sensitivity 10 V)

[2] OUTPUT

Current

A: 4 – 20 mA DC (Load resistance 550 Ω max.)

Z: Specify current (See OUTPUT SPECIFICATIONS)

Voltage

4: 0 – 10 V DC (Load resistance 10 kΩ min.)

5: 0 – 5 V DC (Load resistance 5000 Ω min.)

6: 1 – 5 V DC (Load resistance 5000 Ω min.)

4W: -10 – +10 V DC (Load resistance 20 kΩ min.)

5W: -5 – +5 V DC (Load resistance 10 kΩ min.)

0: Specify voltage (See OUTPUT SPECIFICATIONS)

POWER INPUT

DC Power

R: 24 V DC

(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)

[3] OPTIONS (multiple selections)

Standards & Approvals

blank: CE marking

/UL: UL approval, CE marking

Other Options

blank: none

/Q: Option other than the above (specify the specification)

SPECIFICATIONS OF OPTION: Q

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

GENERAL SPECIFICATIONS

Connection

Input and output: M3 screw terminal (torque 0.5 N·m)

Power input: Via the Installation Base (model: M6NBS)

or M3 screw terminal (torque 0.5 N·m)

Recommended solderless terminal: Max. 5.8 mm (0.23”)

wide; Ones with insulation sleeve do not fit.

Housing material: Flame-resistant resin (black)

Isolation: Input to output to power

Zero adjustment: -2 to +2 % (front)

(Output code 4W, 5W: Adjustable at 0V.)

Span adjustment: 98 to 102 % (front)

Chattering protection: Filter provided for mechanical

contact input

Power LED: Green light turns on when the power is supplied.

■Recommended solderless terminal (unit: mm (inch))

3.2 (.13) dia.

4 min.

(.16)

5.5 max.

(.22)

INPUT SPECIFICATIONS

■ Open Collector

Frequency range: 0 – 0.01 Hz through 100 kHz

Pulse width time requirement: ≥ 4 µsec. for both H and L