2
s Product Specifications
*V.S.W.R. Measurement System
The above V.S.W.R. standard values were measured using the measurement system of the diagram below.
NOTE 1: Cable type connectors were measured with SMA conversion adapters
attached to both ends of the harness product of a suitable 100cm cable.
NOTE 2: Board type connectors were mounted to a 50
Ω glass epoxy board and
measurements were conducted with SMA conversion adapters attached.
Ratings
Nominal characteristic impedance
50
ø
Rated voltage
60 V AC (rms)
Rated frequency
DC to 6 GHz
Operating temperature range
-40˚C to +90˚C
Operating humidity
90% max.
Item
Specification
Conditions
1. Contact resistance
Center: 20 m
ø max.
Outside: 10 m
ø max.
Dia.0.81Cable
1.35
Dia.1.13Cable
1.4
Dia.1.32Cable
1.5
3 to 6 GHz
Measured at 10 mA max.
2. Insulation resistance
3. Withstand voltage
4. V.S.W.R.*
5. Female contact holding force
6. Repetitive operation
7. Vibration
8. Shock
9. Humidity resistance
9. (Steady state)
10. Temperature cycle
11. Salt spray test
500 M
ø min.
No line or insulation breakdown
1.3 max.
0.15 N min.
Contact resistance
25 m
ø max. (Center)
15 m
ø max. (Outside)
No momentary disconnections of 1 µs min.
No damage, cracks, or parts looseness min.
No momentary disconnections of 1 µs min.
No damage, cracks, or parts looseness
No damage, cracks, or parts looseness
Insulation resistance 100 M
ø min.(High temperature)
Insulation resistance 500 M
ø min.(Pry)
No damage, cracks, or parts looseness
Contact resistance 25 m
ø max. (Center)
15 m
ø max. (Outside)
No excessive corrosion
Measured at 100 V DC
200 V AC for 1 minute
DC to 3 GHz
Measured with a Ø 0.475 pin gauge
30 cycles of insertion and disengagement
Frequency of 10 to 100 Hz, single amplitude of 1.5 mm,
acceleration of 59 m/s2, for 5 cyles in the direction of each of the 3 axes
Acceleration of 735 m/s2, 11 ms duration, sine half-wave
waveform, for 6 cycles in the direction of each of the 3 axes
Temperature of 40˚C, humidity of 95%,
let stand for 96 hours
Temperature: +40˚C / 5 to 35˚C
/ +90˚C / 5 to 35˚C
Time:
30 min. / Within 5 min. / 30 min. / Within 5 min.
Cycles: 5
48 hours continuous exposure to 5% salt water
Part
Material
Finish
Remarks
Shell
Phosphor bronze
Silver plating
—————
Male center contact
Brass
Gold plating
—————
Female center contact
Phosphor bronze
Gold plating
—————
Insulator
Plug
Black
UL94V-0
Receptacle
Beige
UL94V-0
LCP
PBT
sMaterials