Electronic Components Datasheet Search
QS30WRQ Datasheet(PDF) 4 Page - Banner Engineering Corp.
BANNER [Banner Engineering Corp.]
QS30WRQ Datasheet(HTML) 4 Page - Banner Engineering Corp.
/ 8 page
Sample/Report Rates: 5 seconds 1
Sample/Report Rates: sample on demand
Modbus/User Configuration Tool (UCT) or DIP Switch Configured
In Modbus/UCT Configured mode, the device parameters are changed using the User Configuration Tool (UCT) or a Modbus
command. All DIP switch positions are ignored. In DIP Switch Configured mode, use the DIP switches to configure the
parameters listed in the table.
Sample and Report Rates
The sample interval, or rate, defines how often the Sure Cross device samples the input. For battery-powered applications,
setting a slower rate extends the battery life.
The report rate defines how often the Node communicates the I/O status to the Gateway. Change of state reporting sets
the system to report only when the value crosses the threshold setting. For FlexPower
applications, setting the report
rate to a slower rate extends the battery life.
Transmit Power Levels
The 900 MHz radios can be operated at 1 watt (30 dBm) or 250 mW (24 dBm). While the Performance radios operate in 1
Watt mode, they cannot communicate with the older 150 mW radios. To communicate with the older 150 mW radios,
operate this radio in 250 mW mode. For 2.4 GHz models, this DIP switch is disabled. The transmit power for 2.4 GHz is
fixed at about 65 mW EIRP (18 dBm), making the 2.4 GHz Performance models automatically compatible with older 2.4
Wiring Your Sure Cross
Use the following wiring diagrams to first wire the sensors and then apply power to the Sure Cross devices.
Refer to the Class I Division 2/Zone 2 control drawings (p/n 143086) for wiring specifications or limitations.
5-Pin M12/Euro-style Female Quick Disconnect
This female quick disconnect fitting interfaces with a 1-wire serial sensor. The following information defines the wires and
the appropriate connection points in the Sure Cross radio.
5-pin M12/Euro-style Female Quick
Power out + (to sensor)
dc common (GND)
5-Pin M12/Euro-Style Male Quick Disconnect
Integral 5-pin M12/Euro-style male quick disconnect (QD)s are wired for 10 to 30 V dc power as shown.
1 Recommended setting for 10–30 V dc powered devices.
www.bannerengineering.com - Tel: +1-763-544-3164
P/N 157189 Rev. I
Does ALLDATASHEET help your business so far?
[ DONATE ]
All Rights Reserved©
| English :
| Chinese :
| German :
| Japanese :
| Korean :
| Spanish :
| French :
| Italian :
| Polish :
| Vietnamese :