Electronic Components Datasheet Search
  English  ▼
ALLDATASHEET.COM

X  

ISL95810WIU8Z-T Datasheet(PDF) 9 Page - Intersil Corporation

Part # ISL95810WIU8Z-T
Description  Single Digitally Controlled Potentiometer (XDCP)
Download  13 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
Manufacturer  INTERSIL [Intersil Corporation]
Direct Link  http://www.intersil.com/cda/home
Logo INTERSIL - Intersil Corporation

ISL95810WIU8Z-T Datasheet(HTML) 9 Page - Intersil Corporation

Back Button ISL95810WIU8Z-T Datasheet HTML 5Page - Intersil Corporation ISL95810WIU8Z-T Datasheet HTML 6Page - Intersil Corporation ISL95810WIU8Z-T Datasheet HTML 7Page - Intersil Corporation ISL95810WIU8Z-T Datasheet HTML 8Page - Intersil Corporation ISL95810WIU8Z-T Datasheet HTML 9Page - Intersil Corporation ISL95810WIU8Z-T Datasheet HTML 10Page - Intersil Corporation ISL95810WIU8Z-T Datasheet HTML 11Page - Intersil Corporation ISL95810WIU8Z-T Datasheet HTML 12Page - Intersil Corporation ISL95810WIU8Z-T Datasheet HTML 13Page - Intersil Corporation  
Zoom Inzoom in Zoom Outzoom out
 9 / 13 page
background image
9
FN8090.1
October 7, 2005
Principles of Operation
The ISL95810 is an integrated circuit incorporating one DCP
with its associated registers, non-volatile memory, and a I2C
serial interface providing direct communication between a
host and the potentiometer and memory.
DCP Description
The DCP is implemented with a combination of resistor
elements and CMOS switches. The physical ends of the
DCP are equivalent to the fixed terminals of a mechanical
potentiometer (RH and RL pins). The RW pin of the DCP is
connected to intermediate nodes, and is equivalent to the
wiper terminal of a mechanical potentiometer. The position
of the wiper terminal within the DCP is controlled by an 8-bit
volatile Wiper Register (WR). The DCP has its own WR.
When the WR of the DCP contains all zeroes (WR<7:0>:
00h), its wiper terminal (RW) is closest to its “Low” terminal
(RL). When the WR of the DCP contains all ones (WR<7:0>:
FFh), its wiper terminal (RW) is closest to its “High” terminal
(RH). As the value of the WR increases from all zeroes (00h)
to all ones (255 decimal), the wiper moves monotonically
from the position closest to RL to the closest to RH. At the
same time, the resistance between RW and RL increases
monotonically, while the resistance between RH and RW
decreases monotonically.
While the ISL95810 is being powered up, The WR is reset to
80h (128 decimal), which locates RW roughly at the center
between RL and RH. Soon after the power supply voltage
becomes large enough for reliable non-volatile memory
reading, the ISL95810 reads the value stored in non-volatile
Initial Value Registers (IVRs) and loads it into the WR.
The WR and IVR can be read or written directly using the
I2C serial interface as described in the following sections.
Memory Description
The ISL95810 volatile and non-volatile registers are
accessed by I2C interface operations at addresses 0 and 2
decimal. The non-volatile byte at addresses 0 contains the
initial value loaded at power-up into the volatile Wiper
Register (WR) of the DCP. The byte at address 1 is
reserved; the user should not write to it, and its value should
be ignored if read.
The volatile WR, and the non-volatile Initial Value Register
(IVR) of the DCP are accessed with the same Address Byte,
set to 00 hex in both cases.
A volatile byte at address 2 decimal, controls what byte is
read or written when accessing DCP registers: the WR, the
IVR, or both.
When the byte at address 2 is all zeroes, which is the default
at power-up:
• A read operation to addresses 0 outputs the value of the
non-volatile IVR.
• A write operation to addresses 0 writes the same value to
the WR and IVR of the corresponding DCP.
When the byte at address 2 is 80h (128 decimal):
• A read operation to addresses 0 outputs the value of the
volatile WR.
• A write operation to addresses 0 only writes to the
corresponding volatile WR.
It is not possible to write to an IVR without writing the same
value to its corresponding WR.
00h and 80h are the only values that should be written to
address 2. All other values are reserved and must not be
written to address 2.
The ISL95810 is pre-programed with 80h in the IVR.
WR: Wiper Register, IVR: Initial value Register.
I2C Serial Interface
The ISL95810 supports a bidirectional bus oriented protocol.
The protocol defines any device that sends data onto the
bus as a transmitter and the receiving device as the receiver.
The device controlling the transfer is a master and the
device being controlled is the slave. The master always
initiates data transfers and provides the clock for both
transmit and receive operations. Therefore, the ISL95810
operates as a slave device in all applications.
All communication over the I2C interface is conducted by
sending the MSB of each byte of data first.
Protocol Conventions
Data states on the SDA line can change only during SCL
LOW periods. SDA state changes during SCL HIGH are
reserved for indicating START and STOP conditions (See
Figure 15). On power-up of the ISL95810 the SDA pin is in
the input mode.
All I2C interface operations must begin with a START
condition, which is a HIGH to LOW transition of SDA while
SCL is HIGH. The ISL95810 continuously monitors the SDA
and SCL lines for the START condition and does not
respond to any command until this condition is met (See
Figure 15). A START condition is ignored during the power-
up sequence and during internal non-volatile write cycles.
All I2C interface operations must be terminated by a STOP
condition, which is a LOW to HIGH transition of SDA while
SCL is HIGH (See Figure 15). A STOP condition at the end
of a read operation, or at the end of a write operation to
TABLE 1. MEMORY MAP
ADDRESS
NON-VOLATILE
VOLATILE
2
-
Access Control
1
Reserved
0IVR
WR
ISL95810


Similar Part No. - ISL95810WIU8Z-T

ManufacturerPart #DatasheetDescription
logo
Intersil Corporation
ISL95810WIU8Z INTERSIL-ISL95810WIU8Z Datasheet
1Mb / 13P
   Low Noise, Low Power I2C Bus, 256 Taps
logo
Renesas Technology Corp
ISL95810WIU8Z RENESAS-ISL95810WIU8Z Datasheet
1Mb / 13P
   Single Digitally Controlled Potentiometer (XDCP?? Low Noise, Low Power I2C Bus, 256 Taps
More results

Similar Description - ISL95810WIU8Z-T

ManufacturerPart #DatasheetDescription
logo
Intersil Corporation
X93156 INTERSIL-X93156_07 Datasheet
190Kb / 7P
   Single Digitally Controlled Potentiometer (XDCP??
ISL22316 INTERSIL-ISL22316 Datasheet
546Kb / 15P
   Single Digitally Controlled Potentiometer XDCP
X9119 INTERSIL-X9119_08 Datasheet
287Kb / 17P
   Single Digitally-Controlled (XDCP?? Potentiometer
X9279 INTERSIL-X9279_09 Datasheet
437Kb / 18P
   Single Digitally-Controlled (XDCP?? Potentiometer
logo
Xilinx, Inc
X9119 XILINX-X9119 Datasheet
125Kb / 22P
   Single Digitally-Controlled (XDCP ??) Potentiometer
logo
Intersil Corporation
X9421 INTERSIL-X9421 Datasheet
367Kb / 21P
   Single Digitally Controlled (XDCP) Potentiometer
logo
Xicor Inc.
X9279 XICOR-X9279 Datasheet
398Kb / 24P
   Single Digitally-Controlled (XDCP) Potentiometer
X9421 XICOR-X9421 Datasheet
117Kb / 21P
   Single Digitally Controlled (XDCP) Potentiometer
logo
Intersil Corporation
X9429 INTERSIL-X9429_08 Datasheet
323Kb / 20P
   Single Digitally Controlled Potentiometer(XDCP??
X9271 INTERSIL-X9271_11 Datasheet
673Kb / 22P
   Single, Digitally Controlled (XDCP?? Potentiometer
More results


Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13


Datasheet Download

Go To PDF Page


Link URL




Privacy Policy
ALLDATASHEET.COM
Does ALLDATASHEET help your business so far?  [ DONATE ] 

About Alldatasheet   |   Advertisement   |   Datasheet Upload   |   Contact us   |   Privacy Policy   |   Link Exchange   |   Manufacturer List
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com