8/15

¡ Semiconductor

MSM511000C/CL

Notes:

1. A start-up delay of 100

µs is required after power-up, followed by a minimum of

eight initialization cycles (RAS-only refresh or CAS before RAS refresh) before

proper device operation is achieved.

4. This parameter is measured with a load circuit equivalent to 2 TTL loads and 100 pF.

is not referenced to output voltage levels.

the cycle is an early write cycle and the data out will remain open circuit (high

cycle and data out will contain data read from the selected cell; if neither of the above

sets of conditions is satisfied, then the condition of the data out (at access time) is

indeterminate.

10. These parameters are referenced to the CAS leading edge in an early write cycle, and

to the WE leading edge in a read modify write cycle.