Electronic Components Datasheet Search |
|
U4256BM-RFS Datasheet(PDF) 3 Page - ATMEL Corporation |
|
U4256BM-RFS Datasheet(HTML) 3 Page - ATMEL Corporation |
3 / 19 page 3 U4256BM-R 4562C–AUDR–08/04 Functional Description For a tuned FM-broadcast receiver, the following parts are needed: • Voltage-Controlled Oscillator (VCO) • Antenna Amplifier Tuned Circuit • RF Amplifier Tuned Circuit Typical modern receivers with electronic tuning are tuned to the desired FM frequency by the frequency synthesizer IC U4256BM-R. The special design allows the user to build software-controlled tuner alignment systems. Two programmable DACs (Digital-to- Analog Converter) support the computer-controlled alignment. The output of the PLL is a tuning voltage which is connected to the VCO of the receiver IC. The output of the VCO is equal to the desired station frequency plus the IF (10.7 MHz). The RF and the oscillator signal (VCO) are both input to the mixer that translates the desired FM chan- nel signal to the fixed IF signal. For FM, the double-conversion system of the receiver requires exactly 10.7 MHz for the first IF frequency, which determines the center fre- quency of the software-controlled integrated second IF filter. If this oscillator tuning feature is not used, the internal capacities have to be switched off and the oscillator has to be operated with high-quality external capacities to ensure that the operational frequency is exactly 10.250 MHz. When dimensioning the oscillator circuit, it is important that the additional capacities enable the oscillator to operate through its complete tracking range. The oscillating abil- ity depends very strongly on the used crystal oscillator. Initializing the oscillator should be established without switching any additional capacities to guarantee that the oscilla- tor starts to operate properly. Due to the lower quality of the integrated capacities compared to discrete capacities, the amount of the switched integrated capacities should always be minimized. (If necessary reduce tracking range or use another crystal oscillator.) The U4256BM-R has a very fast response time of maximum 800 µs (at 2 mA, f Step = 50 kHz, measured on MPX signal). It performs a high signal to noise ratio. Only one supply voltage is necessary, due to a integrated band gap. Input/Output Interface Circuits PDO (Pin 1) PDO is the buffer amplifier output of the PLL. The bipolar output stage is a rail-to-rail amplifier. PD (Pin 2) PD is the current charge pump output of the PLL. The current can be controlled by setting the Bits. The loop filter has to be designed corresponding to the choosen pump current and the internal reference frequency. A recommendation can be found in the application circuit. The charge-pump current can be choosen by setting the Bits 71 and 70 as following: IPD (µA) B71 B70 25 0 0 100 0 1 500 1 0 2000 1 1 |
Similar Part No. - U4256BM-RFS |
|
Similar Description - U4256BM-RFS |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.COM |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Datasheet Upload | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |