IS42S16400A datasheet(8/55 Pages) ISSI

Part #	IS42S16400A

Description	1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM

Download	55 Pages

Scroll/Zoom	100%

Manufacturer	ISSI [Integrated Silicon Solution, Inc]

Direct Link	http://www.issi.com

Logo

8 / 55 page

IS42S16400A

ISSI®

8

Integrated Silicon Solution, Inc. — www.issi.com — 1-800-379-4774

Rev.C

04/16/03

NOTE:

1. This table applies when CKE n-1 was HIGH and CKE n is HIGH (see Truth Table - CKE) and after tXSR has been met (if the

previous state was SELF REFRESH).

2. This table is bank-specific, except where noted; i.e., the current state is for a specific bank and the commands shown are those

allowed to be issued to that bank when in that state. Exceptions are covered in the notes below.

3. Current state definitions:

Idle: The bank has been precharged, and tRP has been met.

Row Active: A row in the bank has been activated, and tRCD has been met. No data bursts/accesses and no register

accesses are in progress.

Read: A READ burst has been initiated, with auto precharge disabled, and has not yet terminated or been terminated.

Write: A WRITE burst has been initiated, with auto precharge disabled, and has not yet terminated or been terminated.

4. The following states must not be interrupted by a command issued to the same bank. COMMAND INHIBIT or NOP commands, or

allowable commands to the other bank should be issued on any clock edge occurring during these states. Allowable commands to

the other bank are determined by its current state and CURRENT STATE BANK n truth tables.

Precharging: Starts with registration of a PRECHARGE command and ends when tRP is met. Once tRP is met, the bank

will be in the idle state.

Row Activating: Starts with registration of an ACTIVE command and ends when tRCD is met. Once tRCD is met, the bank will

be in the row active state.

Read w/Auto

Precharge Enabled: Starts with registration of a READ command with auto precharge enabled and ends when tRP has been met.

Once tRP is met, the bank will be in the idle state.

Write w/Auto

Precharge Enabled: Starts with registration of a WRITE command with auto precharge enabled and ends when tRP has been met.

Once tRP is met, the bank will be in the idle state.

5. The following states must not be interrupted by any executable command; COMMAND INHIBIT or NOP commands must be

applied on each positive clock edge during these states.

Refreshing: Starts with registration of an AUTO REFRESH command and ends when tRC is met. Once tRC is met, the

SDRAM will be in the all banks idle state.

Accessing Mode

Register: Starts with registration of a LOAD MODE REGISTER command and ends when tMRD has been met. Once

tMRD is met, the SDRAM will be in the all banks idle state.

Precharging All: Starts with registration of a PRECHARGE ALL command and ends when tRP is met. Once tRP is met, all

banks will be in the idle state.

6. All states and sequences not shown are illegal or reserved.

7. Not bank-specific; requires that all banks are idle.

8. May or may not be bank-specific; if all banks are to be precharged, all must be in a valid state for precharging.

9. Not bank-specific; BURST TERMINATE affects the most recent READ or WRITE burst, regardless of bank.

10. READs or WRITEs listed in the Command (Action) column include READs or WRITEs with auto precharge enabled and READs

or WRITEs with auto precharge disabled.

11. Does not affect the state of the bank and acts as a NOP to that bank.

Similar Part No. - IS42S16400A

Manufacturer	Part #	Datasheet	Description
Integrated Circuit Solu...	IS42S16400	1Mb / 68P	2(1)M words x 8(16) bits x 4 banks (64-mbit) synchronous dynamic ram
Integrated Silicon Solu...	IS42S16400	557Kb / 54P	1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM
	IS42S16400	675Kb / 55P	1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM
	IS42S16400-10T	557Kb / 54P	1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM
	IS42S16400-10TI	557Kb / 54P	1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM

More results

Similar Description - IS42S16400A

Manufacturer	Part #	Datasheet	Description
Integrated Silicon Solu...	IS42S16400E	848Kb / 55P	1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM
List of Unclassifed Man...	IS42S16400B	472Kb / 55P	1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM
Integrated Silicon Solu...	IS45S16400C1	487Kb / 55P	1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM
	IS42S16400F	1Mb / 58P	1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM
	IS42S16400	675Kb / 55P	1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM
	IS42S16400J-6TL	1Mb / 60P	1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM
	IS42S16400	557Kb / 54P	1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM
	IS42VS16400C1	491Kb / 56P	1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM
	IS42S16400C1	487Kb / 55P	1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM
	IS42S16400D	562Kb / 57P	1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM

More results

IS42S16400A Datasheet(PDF) 8 Page - Integrated Silicon Solution, Inc

IS42S16400A Datasheet(HTML) 8 Page - Integrated Silicon Solution, Inc

Similar Part No. - IS42S16400A

Similar Description - IS42S16400A

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55

Datasheet Download

Link URL