DS107 LUXEON Rebel PLUS Product Datasheet 20170712 ©2017 Lumileds Holding B.V. All rights reserved.

4

Electrical and Thermal Characteristics

Table 3. Electrical and thermal characteristics for LUXEON Rebel PLUS at 350mA, T

Part numBer

tyPIcal temPerature

coeFFIcIent oF ForWard

tyPIcal thermal

resIstance—JunctIon

to solder Pad (°c/W)

mInImum

tyPIcal

maXImum

LX18-P127-x

2.5

2.8

3.0

-1.0 to -3.0

9.0°

LX18-P130-x

2.5

2.8

3.0

-1.0 to -3.0

9.0°

LX18-P135-x

2.5

2.8

3.0

-1.0 to -3.0

9.0°

LX18-P140-x

2.5

2.8

3.0

-1.0 to -3.0

9.0°

LX18-P150-x

2.5

2.8

3.0

-1.0 to -3.0

9.0°

Notes for Table 3:

1. Lumileds maintains a tolerance of ±0.06V on forward voltage measurements.

2. Measured between 25°C and 110°C.

Absolute Maximum Ratings

Table 4. Absolute maximum ratings for LUXEON Rebel PLUS.

Parameter

maXImum PerFormance

1000mA

1000mA

150°C

ESD Sensitivity (ANSI/ESDA/JEDEC JS-001-2012)

< 8000V Human Body Model (HBM) Class 3A JESD22-A114-E

-40°C to 135°C

LED Storage Temperature

-40°C to 135°C

Soldering Temperature

JEDEC 020c 260°C

Allowable Reflow Cycles

3

Reverse Voltage (V

LUXEON LEDs are not designed to be driven in reverse bias

Notes for Table 4:

1. Proper current derating must be observed to maintain the junction temperature below the maximum allowable junction temperature.

2. Residual periodic variations due to power conversion from alternating current (AC) to direct current (DC), also called “ripple,” are acceptable if the following conditions are met:

– The frequency of the ripple current is 100Hz or higher

– The average current for each cycle does not exceed the maximum allowable DC forward current

– The maximum amplitude of the ripple does not exceed the maximum peak pulsed forward current

3. Pulsed operation with the maximum peak pulsed forward current is acceptable if the pulse on-time is ≤5ms per cycle and the duty cycle is ≤50%.