filter. The magnitudes are referenced to a DC gain of 0.0 dB.

els).

Note 6: The short circuit source current is measured by forcing the output that is being tested to its maximum positive voltage swing and then shorting that output

to the negative supply. The short circuit sink current is measured by forcing the output that is being tested to its maximum negative voltage swing and then shorting

that output to the positive supply. These are the worst-case conditions.

Note 7: The MF6 is operating with symmetrical split supplies and L.Sh is tied to ground.

Note 8: Typicals are at 25˚C and represent most likely parametric norm.

Note 9: Tested limits are guaranteed to National’s AOQL (Average Outgoing Quality Level).

Note 10: Design limits are guaranteed, but not 100% tested. These limits are not used to calculate outgoing quality levels.

Note 11: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. DC and AC electrical specifications do not apply when operating

the device beyond its specified conditions.

Note 12: Human body model, 100 pF discharged through a 1.5k

Ω resistor.

to 5 mA or less. The 20 mA package input current limits the number of pins that can exceed the power supply boundaries witha5mA current limit to four.

Typical Performance Characteristics

Schmitt Trigger Threshold Voltage

vs Power Supply Voltage

DS005065-40

Crosstalk from Filter

to Op-Amps (MF6-100)

DS005065-41

Crosstalk from Either Op-Amp

to Filter Output (MF6-50)

DS005065-42

Crosstalk from Filter

to Op-Amps (MF6-50)

DS005065-43

Crosstalk from Either Op-Amp to

Filter Output (MF6-100)

DS005065-44

Equivalent Input Noise

Voltage of Op-Amps

DS005065-45

www.national.com

5