Electronic Components Datasheet Search |
|
2-21002-1 Datasheet(PDF) 1 Page - TE Connectivity Ltd |
|
2-21002-1 Datasheet(HTML) 1 Page - TE Connectivity Ltd |
1 / 3 page ©2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company All Rights Reserved *Trademark TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners. 1 of 3 Instruction Sheet TOOLING ASSISTANCE CENTER 1-800-722-1111 PRODUCT INFORMATION 1-800-522-6752 This controlled document is subject to change. For latest revision and Regional Customer Service, visit our website at www.te.com LOC B 408-8996 Seating Tool Assembly 1213670-1 For Stacked RJ-45 Integrated Connector Assembly 19 DEC 11 Rev A Figure 1 Alignment Post Compliant-Pin Contact PC Board Support Fixture (Ref) Printed Circuit (PC) Board (Ref) Stacked RJ-45 Integrated Connector Assembly Cutout Top Block Back Plate Side Plate (2 Places) 1. INTRODUCTION Seating Tool Assembly 1213670-1 is used to seat a stacked RJ-45 integrated connector assembly (reference part number 1658821-1) having compliant pin contacts and alignment posts onto the pc board. Refer to Application Specification 114-13147 for description of connector assembly. NOTE i All numerical values in this instruction sheet are in metric units [with U.S. customary units in brackets]. Dimensions are in millimeters [and inches]. Figures are not drawn to scale. 2. DESCRIPTION The seating tool consists of a top block, two side plates, and a back plate. The back plate has a cutout designed to accept the power-over-ethernet (PoE) chip set of the connector assembly during seating of the connector assembly. See Figure 1. The top block provides a surface to accept the force applied by the application tool to seat the connector assembly onto the pc board. During seating, the top block and side plates protect the connector assembly, and the back plate supports the back of the connector assembly. 3. REQUIREMENTS 3.1. PC Board Support Fixture (Customer Supplied) A pc board support must be used to provide proper support for the pc board and to protect the pc board and the connector and connector assembly from damage. The support fixture must be designed for specific needs using the following recommendations: • it should be at least 25.4 mm [1.0 in.] longer and wider than the pc board • it should have flat surfaces with holes or a channel large enough and deep enough to receive any protruding components of the connector assembly 3.2. Application Tool Power for seating tools must be provided by an application tool (with a ram) capable of supplying a downward force of 44.5 N [10 lb-force] per contact. |
Similar Part No. - 2-21002-1 |
|
Similar Description - 2-21002-1 |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.COM |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Datasheet Upload | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |