408-8340

2 of 3

Rev B

3. INSTALLATION

It is necessary to open or remove machine covers

to perform the following procedure. Be sure to

replace ALL covers BEFORE operating the

machine.

The cable clamp's pivot bracket attaches to the

machine carriage, and the cam track assembly

mounts to the machine's base block assembly. To

mount the clamp:

1. Turn off the machine's air supply by disengaging

the air supply at the back of the machine.

2. Turn off the machine's electrical functions by

switching the rocker switch on the back of the

machine's control module.

DO NOT make adjustments to the machine or the

cable clamp while the machine is operational. Make

sure to disable the machine to prevent it from

moving while adjustments are being made.

3. Attach the pivot bracket to the back of the

machine carriage with the No. 10-32 screws

provided. Refer to Figure 2. Using a 5/32-in. hex

wrench, tighten the screws.

Figure 2

4. Slide the bottom of the cam track assembly onto

the rack portion of the base block assembly. Make

sure that the cam track assembly mounting screw is

raised to allow the cam track to slide.

5. Adjust the position of the cam track assembly to

Dimension A shown in Figure 3 to ensure that the

cable is located for either straight exit or angle exit.

6. Using a 5/32-in. hex wrench, tighten the mounting

screw to secure the cam track.

Figure 3

7. On the machine, plug the air hose from the clamp

solenoid valve (see Figure 4) onto the fitting of the

cable clamp (refer to Figure 1).

8. Turn on the air to the machine, and inspect the

cable clamp for air leaks.

4. TOOLING ADJUSTMENTS

To avoid personal injury, DISCONNECT air and

electric power before making adjustments to the

machine or cable clamp. DO NOT make

adjustments while the machine is operational.

4.1. Cable Clamp Position

The position of the cable clamp can be adjusted to

vary the cable exit position relative to the connector.

To adjust this position, refer to Figure 3, and proceed

as follows:

DANGER

STOP

DANGER

STOP

Pivot

Bracket

Screws and

Washers

Carriage

CONNECTOR

DIMENSION “A”

TYPE

SIZE

STRAIGHT

EXIT

ANGLE

EXIT

AMPLIMITE .050

20

2.54 [.100]

1.27 [.050]

40

5.58 [.220]

13.97 [.550]

50

8.38 [.330]

15.24 [.600]

68

13.20 [.520]

26.67 [1.050]

80

17.01 [.670]

34.29 [1.350]

100

23.62 [.930]

46.99 [1.850]

120

33.52 [1.320]

55.88 [2.200]

AMPLIMITE HDE

All

18.54 [.730]

---

CHAMP

All

Mounting

Screw

Dimension “A”

(See Table)

Base Block

Assembly (Ref)

DANGER

STOP