Instruction Sheet

1 of 4

© 2015 TE Connectivity family of companies

All Rights Reserved

*Trademark

TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.

PRODUCT INFORMATION 1-800-522-6752

This controlled document is subject to change.

For latest revision and Regional Customer Service,

visit our website at www.te.com.

408-32208

19 OCT 15

Rev A

SEATING

TOOL KIT

QSFP CAGE ASSEMBLY

CONFIGURATION

APPLICATION

SPECIFICATION

REPLACEMENT WALL

SUPPORT

CAGE ASSEMBLY

CONFIGURATION

2215032-1

1 X 6

114-13120

2-2215032-1

1 X 6

2215032-2

1 X 3

2-2215032-2

1 X 3

2215032-3

1 X 4

2-2215032-3

1 X 4

Figure 1

1. INTRODUCTION

QSFP cage assembly seating tool listed in Figure 1 is used to seat the cage assembly described in Figure 1

onto the pc board. The cage assembly contains compliant pin contacts to allow solderless pc board installation.

Read these instructions thoroughly before using the seating tool kit.

NOTE

Dimensions on this sheet are in metric units [with U.S. customary units in brackets]. Figures and illustrations are for reference

only and are not drawn to scale.

Each seating tool consists of a seating tool and a wall support. The seating tool has cutouts (two located on

each side) to accept the protruding part of the standoffs of the cage assembly. The wall support must be

installed into the ports of the cage assembly.

The top of the seating tool provides a surface to accept the force applied by the application tool to seat the

product onto the pc board. During seating, the back and sides of the seating tool protect the cage assembly

from damage. The wall support supports the individual ports of the cage assembly.

3. REQUIREMENTS

A pc board support must be used to provide proper support for the pc board and to protect the pc board and

the connector and cage assembly from damage. The support fixture must be designed for specific needs using

the following recommendations:

Small Form-Factor Pluggable (QSFP

Behind Bezel, Customized Heat Sink)

Cage Assembly Seating Tool 2215032-[ ]

Back of

Seating Tool

1 X 6 Seating Tool

(Bottomed on Cage Assembly)

Compliant

Pin Contact

1 X 6 Cage Assembly

2143331-7

1 X 6 Wall Support

(For Clarity, Not Shown Installed)

PC Board Support

Fixture (Ref)

Printed Circuit

(PC) Board (Ref)