408-4250

Seating Tools 318860-[ ]

Rev C

4 of 4

Tyco Electronics Corporation

Regular inspections should be performed by quality

control personnel. A record of scheduled inspections

should remain with the tool or be supplied to

supervisory personnel responsible for the tool. The

inspection frequency should be based on the amount

of use, working conditions, operator training and skill,

and established company standards.

6. MAINTENANCE

It is recommended that each operator be made aware

of, and responsible for, the following steps of daily

maintenance:

1. Remove dust, moisture, and other contaminants

with a clean, soft brush, or lint–free cloth. Do NOT

use objects that could damage the tool.

2. Ensure that the screws are in place and

secured.

3. When the tool is not in use, store it in a clean,

dry area.

7. REPLACEMENT AND REPAIR

The parts listed in Figure 2 are customer–

replaceable. A complete inventory should be stocked

and controlled to prevent lost time when replacement

of parts is necessary. Parts other than those listed

should be replaced by Tyco Electronics to ensure

quality and reliability. Order replacement parts

through your representative, or call 1–800–526–5142,

or send a facsimile of your purchase order to

717–986–7605, or write to:

CUSTOMER SERVICE (038–035)

TYCO ELECTRONICS CORPORATION

PO BOX 3608

HARRISBURG PA 17105–3608

8. REVISION SUMMARY

Since the previous release of this instruction sheet,

the logo was changed.